This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


D15 /I600 Questions
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
Gary Burnett View Drop Down
Orange Level Access
Orange Level Access
Avatar

Joined: 11 Sep 2009
Location: Virginia
Points: 3101 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Gary Burnett Quote  Post ReplyReply Direct Link To This Post Topic: D15 /I600 Questions
    Posted: 13 Jun 2020 at 3:47pm
I've had an I600 w/loader on it for awhile,runs good,transmission and reverser are pretty well shot.
Today I bought a D15 diesel with a locked up motor but what I'm pretty sure is a rear with good gears in it.If I try to swap the whole rear/torque tube out of the diesel and mate it to the motor  in the I600 what problems will I run into or changes I need to make?
Back to Top
Sponsored Links


Back to Top
DrAllis View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Points: 22159 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DrAllis Quote  Post ReplyReply Direct Link To This Post Posted: 13 Jun 2020 at 7:28pm
Your I-600 shuttle clutch gearing (forward/reverse) are inside the torque tube, so you will lose that and then have high/low.
Back to Top
Calvin Schmidt View Drop Down
Orange Level
Orange Level
Avatar

Joined: 11 Sep 2009
Location: Ontario Can.
Points: 4556 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Calvin Schmidt Quote  Post ReplyReply Direct Link To This Post Posted: 13 Jun 2020 at 7:29pm
The I 600 will have a set of gears ahead of the shuttle/power director pack that reverses what is the low range half on a power director making it a shuttle. Everything should bolt up OK but you will have to swap the shuttle gears into the D-15 to get the shuttle. Since the D-15 is a diesel and I assume the I 600 is a gas you will likely also have to swap the input shafts

Edited by Calvin Schmidt - 13 Jun 2020 at 7:29pm
Nothing is impossible if it is properly financed
Back to Top
Gary Burnett View Drop Down
Orange Level Access
Orange Level Access
Avatar

Joined: 11 Sep 2009
Location: Virginia
Points: 3101 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Gary Burnett Quote  Post ReplyReply Direct Link To This Post Posted: 14 Jun 2020 at 1:36am
Thanks,I want to have the ag set up with the high/low rather than the shuttle especially since my shuttle now doesn't work very well.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.067 seconds.


Help Support the
Unofficial Allis Forum