This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


thread locker on rod bolts????
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
tractorboy View Drop Down
Silver Level
Silver Level


Joined: 03 Oct 2009
Location: southern Va
Points: 475 		Post Options Post Options   Thanks (0) Thanks(0)   Quote tractorboy Quote  Post ReplyReply Direct Link To This Post Topic: thread locker on rod bolts????
    Posted: 28 Mar 2010 at 8:08pm
I asked at napa for the pal locking nuts, he had none. What do you guys use to make sure the rod bolts stay tight??    PS, I'll be putting the engine back in the B, and will use a 3/16 plate to give me clearance between the clutch shaft and the crankshaft. I know this is unheard of, but it's ouick and easy!  Keith
Back to Top
Sponsored Links


Back to Top
CTuckerNWIL View Drop Down
Orange Level
Orange Level
Avatar

Joined: 11 Sep 2009
Location: NW Illinois
Points: 22825 		Post Options Post Options   Thanks (0) Thanks(0)   Quote CTuckerNWIL Quote  Post ReplyReply Direct Link To This Post Posted: 28 Mar 2010 at 8:15pm
Wire
http://www.ae-ta.com
Lena 1935 WC12xxx, Willie 1951 CA6xx Dad bought new, 1954WD45 PS, 1960 D17 NF
Back to Top
Gerald J. View Drop Down
Orange Level
Orange Level


Joined: 12 Sep 2009
Location: Hamilton Co, IA
Points: 5636 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Gerald J. Quote  Post ReplyReply Direct Link To This Post Posted: 28 Mar 2010 at 8:30pm
McMaster-Carr www.mcmaster.com has Palnuts.
http://www.mcmaster.com/#palnuts/=6f5rxg

Not expensive either, if they have the size you need, I hope 3/8" fine thread.

Gerald J.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.104 seconds.


Help Support the
Unofficial Allis Forum