This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


220 front end

 Post Reply Post Reply
Author
Message
Riggs/Ia View Drop Down
Silver Level
Silver Level


Joined: 12 Apr 2010
Location: Iowa
Points: 69
Post Options Post Options   Thanks (0) Thanks(0)   Quote Riggs/Ia Quote  Post ReplyReply Direct Link To This Post Topic: 220 front end
    Posted: 08 May 2010 at 3:48pm
Does anyone know if the front oscilating pin is pressed in or is that suppose to be loose with a couple thousandths clearence? Had a 10ton portapower and a 25lbs slide hammer on the front and did not move at all!!! Can't heat because the sleeve is in the front end and can only see the end 1/2" of it. Had to take whole front end off and air-arc it out and have a new one machined. If anyone ever did this let me know, Thanks in advance Mark
Back to Top
Sponsored Links


Back to Top
Luke R. View Drop Down
Orange Level
Orange Level


Joined: 11 Sep 2009
Location: SE Iowa
Points: 1262
Post Options Post Options   Thanks (0) Thanks(0)   Quote Luke R. Quote  Post ReplyReply Direct Link To This Post Posted: 08 May 2010 at 6:33pm
I thought they had a bolt that went thru them to hold them in place, at least thats the way it is on a D21 front end. It might be different for a two twenty front end. I took the whole front bolster off of our D21 and put the wish bone in a big press we have at work and it pushed it right out. Im almost positive their is a bolt that holds it into the front wish bone. I have been wrong before though LOL
4-7030's,170G,220FWA,3-220's,210,D21II,D21I industrial,2-200's,3-190's,175D,2-D19D's,D19G,WD45,WD,CA,2-UCont.,5015FWA,917,B110,Gleaner F
Back to Top
Riggs/Ia View Drop Down
Silver Level
Silver Level


Joined: 12 Apr 2010
Location: Iowa
Points: 69
Post Options Post Options   Thanks (0) Thanks(0)   Quote Riggs/Ia Quote  Post ReplyReply Direct Link To This Post Posted: 08 May 2010 at 7:18pm
yes there is a bolt that holds it in but the main pin is so tight i had to air arc it out and when i did i beat on it with a sledge hammer and it just bounced off of it. just was wondering if it might be pressed because it was so tight in there!
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.082 seconds.


Help Support the
Unofficial Allis Forum