220 front end
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=12152
Printed Date: 30 Jan 2025 at 9:23pm Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: 220 front end
Posted By: Riggs/Ia
Subject: 220 front end
Date Posted: 08 May 2010 at 3:48pm
Does anyone know if the front oscilating pin is pressed in or is that suppose to be loose with a couple thousandths clearence? Had a 10ton portapower and a 25lbs slide hammer on the front and did not move at all!!! Can't heat because the sleeve is in the front end and can only see the end 1/2" of it. Had to take whole front end off and air-arc it out and have a new one machined. If anyone ever did this let me know, Thanks in advance Mark
|
Replies:
Posted By: Luke R.
Date Posted: 08 May 2010 at 6:33pm
I thought they had a bolt that went thru them to hold them in place, at least thats the way it is on a D21 front end. It might be different for a two twenty front end. I took the whole front bolster off of our D21 and put the wish bone in a big press we have at work and it pushed it right out. Im almost positive their is a bolt that holds it into the front wish bone. I have been wrong before though LOL
------------- 4-7030's,170G,220FWA,3-220's,210,D21II,D21I industrial,2-200's,3-190's,175D,2-D19D's,D19G,WD45,WD,CA,2-UCont.,5015FWA,917,B110,Gleaner F
|
Posted By: Riggs/Ia
Date Posted: 08 May 2010 at 7:18pm
yes there is a bolt that holds it in but the main pin is so tight i had to air arc it out and when i did i beat on it with a sledge hammer and it just bounced off of it. just was wondering if it might be pressed because it was so tight in there!
|
|