WC Questions for the experts

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

     My next project has been drug in and I'm cleaning up and Inspecting .   I started at the front and after cleaning the  inside of the support  found the stop is broken both in the support and chipped away from the under side of the gear, allowing the worm to screw itslf right off the gear. I assumed the easiest way to dissassemble would be to drop the spindle block, I 've removed the bottom bolt and set screw, It don't wanna drop off , What's the trick?  Heat and a BFH ?  I assume that once the spindle block is off I can pull the shaft and gear thru the top of the support?  I'd like to replace the seals ,too while I'm in there.  Also the spindle block has a scraper? built in , I have never seen one like this , is it uncommon ? Thanks , Gary  

,

Edited by Gary in da UP - 29 Jan 2010 at 4:44pm

	This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
	The Forum	Parts and Services	Unofficial Allis Store	Tractor Shows	Serial Numbers	History

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
Gary in da UP Members Profile Send Private Message Find Members Posts Add to Buddy List Orange Level Joined: 13 Sep 2009 Location: EUP of Mi. Points: 1885	Post Options Post Reply Quote Gary in da UP Report Post Thanks(0) Quote Reply Topic: WC Questions for the experts Posted: 29 Jan 2010 at 2:54pm
	My next project has been drug in and I'm cleaning up and Inspecting . I started at the front and after cleaning the inside of the support found the stop is broken both in the support and chipped away from the under side of the gear, allowing the worm to screw itslf right off the gear. I assumed the easiest way to dissassemble would be to drop the spindle block, I 've removed the bottom bolt and set screw, It don't wanna drop off , What's the trick? Heat and a BFH ? I assume that once the spindle block is off I can pull the shaft and gear thru the top of the support? I'd like to replace the seals ,too while I'm in there. Also the spindle block has a scraper? built in , I have never seen one like this , is it uncommon ? Thanks , Gary , Edited by Gary in da UP - 29 Jan 2010 at 4:44pm

Sponsored Links

JoeM(GA) Members Profile Send Private Message Find Members Posts Add to Buddy List Orange Level Joined: 12 Sep 2009 Location: Cumming,GA Points: 4700	Post Options Post Reply Quote JoeM(GA) Report Post Thanks(0) Quote Reply Posted: 29 Jan 2010 at 7:29pm
	Gary, shouldn't be anything else but crud and the key holding it up
	Allis Express North Georgia 41 WC,48 UC Cane,7-G's, Ford 345C TLB