This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


D 19 power director question
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
bill(IL) View Drop Down
Bronze Level
Bronze Level


Joined: 14 Sep 2009
Location: Illinois
Points: 19 		Post Options Post Options   Thanks (0) Thanks(0)   Quote bill(IL) Quote  Post ReplyReply Direct Link To This Post Topic: D 19 power director question
    Posted: 22 Jan 2010 at 7:21pm
My D 19 power director pops out of low range while going down hill. will be splitting tractor to replace seals. Can someone tell me possible causes for it to pop out?   Thanks     Bill
Back to Top
Sponsored Links


Back to Top
Austin(WI) View Drop Down
Orange Level
Orange Level
Avatar

Joined: 11 Sep 2009
Location: Wisconsin
Points: 1460 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Austin(WI) Quote  Post ReplyReply Direct Link To This Post Posted: 22 Jan 2010 at 9:24pm
Ours did the same thing...The little rollers that engaged and disengauge the clutch pack may be worn out. Check them
"Better By Design"
Back to Top
Austin(WI) View Drop Down
Orange Level
Orange Level
Avatar

Joined: 11 Sep 2009
Location: Wisconsin
Points: 1460 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Austin(WI) Quote  Post ReplyReply Direct Link To This Post Posted: 22 Jan 2010 at 9:29pm
http://www.agcopartsbooks.com/EpsilonWeb/book.aspx?book=agco/79001554
"Better By Design"
Back to Top
Skyhighballoon(MO) View Drop Down
Orange Level
Orange Level
Avatar

Joined: 11 Sep 2009
Location: Pilot Grove, MO
Points: 3115 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Skyhighballoon(MO) Quote  Post ReplyReply Direct Link To This Post Posted: 22 Jan 2010 at 10:19pm
Yes, rollers (3 per side) can get flat spotted.  Rollers were $15 each from AGCO in 2006 when I did my D17 Series IV.  Also the feed ramps they roll on get worn, have to be built up and machined back down.  Moving shims to tighten up the clutch will make it pop out worse.  Mike
1981 Gleaner F2 Corn Plus w 13' flex
1968 Gleaner EIII w 10' & 330
1969 180 gas
1965 D17 S-IV gas
1963 D17 S-III gas
1956 WD45 gas NF PS
1956 All-Crop 66 Big Bin
303 wire baler, 716H, 712H mowers
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.066 seconds.


Help Support the
Unofficial Allis Forum