Farm Equipment - D 19 power director question

Print Page | Close Window

D 19 power director question

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=7002
Printed Date: 16 Jan 2025 at 3:54pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: D 19 power director question

Posted By: bill(IL)
Subject: D 19 power director question
Date Posted: 22 Jan 2010 at 7:21pm

My D 19 power director pops out of low range while going down hill. will be splitting tractor to replace seals. Can someone tell me possible causes for it to pop out? Thanks Bill

Replies:

Posted By: Austin(WI)
Date Posted: 22 Jan 2010 at 9:24pm

Ours did the same thing...The little rollers that engaged and disengauge the clutch pack may be worn out. Check them

-------------
"Better By Design"

Posted By: Austin(WI)
Date Posted: 22 Jan 2010 at 9:29pm

http://www.agcopartsbooks.com/EpsilonWeb/book.aspx?book=agco/79001554 - http://www.agcopartsbooks.com/EpsilonWeb/book.aspx?book=agco/79001554

-------------
"Better By Design"

Posted By: Skyhighballoon(MO)
Date Posted: 22 Jan 2010 at 10:19pm

Yes, rollers (3 per side) can get flat spotted. Rollers were $15 each from AGCO in 2006 when I did my D17 Series IV. Also the feed ramps they roll on get worn, have to be built up and machined back down. Moving shims to tighten up the clutch will make it pop out worse. Mike

-------------
1981 Gleaner F2 Corn Plus w 13' flex
1968 Gleaner EIII w 10' & 330
1969 180 gas
1965 D17 S-IV gas
1963 D17 S-III gas
1956 WD45 gas NF PS
1956 All-Crop 66 Big Bin
303 wire baler, 716H, 712H mowers