| Author |
 Topic Search  Topic Options
|
Robacpuller 
Silver Level
Joined: 07 Apr 2016
Location: Wisconsin
Points: 248
|
 Post Options
 Thanks(0)
 Quote  Reply
 Topic: Gearing for wc
Posted: 09 Sep 2017 at 10:18pm |
|
Can a wd trans. Fit in a wc and r they geared diferently. Can a wc reared gears b changed to lower gear ratio
|
 |
|
Sponsored Links
|
|
|
mike a
Bronze Level
Joined: 12 Dec 2009
Location: MN
Points: 165
|
Post Options
Thanks(0)
Quote Reply
Posted: 10 Sep 2017 at 8:40am |
|
rc gears can be put into a wc housing,easier to swap the whole rc rear-end,geared about 1 gear lower
|
|
AaronSEIA
Orange Level
Joined: 11 Sep 2009
Location: Mt Pleasant, IA
Points: 2551
|
Post Options
Thanks(0)
Quote Reply
Posted: 10 Sep 2017 at 12:20pm |
|
Tranny cannot be swapped. An RC ring and pinion is what most use to get slowed down. Or find a 2 speed gearbox.
AaronSEIA
|
|
Robacpuller
Silver Level
Joined: 07 Apr 2016
Location: Wisconsin
Points: 248
|
Post Options
Thanks(0)
Quote Reply
Posted: 13 Sep 2017 at 10:01pm |
|
Did not know they made a 2 speed gear box for wc. Do they mount behind trans. Any Allis folks have one?
|
|
CAL(KS)
Orange Level
Joined: 18 Sep 2009
Location: Chapman, KS
Points: 3786
|
Post Options
Thanks(0)
Quote Reply
Posted: 14 Sep 2017 at 8:14am |
it goes on the pinion shaft behind the trans where the cult lift is and you have to have a short pinion like on the styled tractors with the release for it to fit. there are overdrives and underdrives and are some both I think. several different companies made them
|
|
Me -C,U,UC,WC,WD45,190XT,TL-12,145T,HD6G,HD16,HD20
Dad- WD, D17D, D19D, RT100A, 7020, 7080,7580, 2-8550's, 2-S77, HD15
|
|
Robacpuller
Silver Level
Joined: 07 Apr 2016
Location: Wisconsin
Points: 248
|
Post Options
Thanks(0)
Quote Reply
Posted: 14 Sep 2017 at 6:07pm |
|
Cal u don't have one do u? What about yhe unstyled wc,is there a different one?
|
|
CAL(KS)
Orange Level
Joined: 18 Sep 2009
Location: Chapman, KS
Points: 3786
|
Post Options
Thanks(0)
Quote Reply
Posted: 15 Sep 2017 at 7:45am |
|
no I don't have one. would like to find one for my brothers 38 unstyled. couple guys in my club run them. as far as I know you cannot use one in an unstyled tractor unless you switch out the pinion in which case usually just means the whole pumpkin as its easier.
Edited by CAL(KS) - 15 Sep 2017 at 7:46am
|
|
Me -C,U,UC,WC,WD45,190XT,TL-12,145T,HD6G,HD16,HD20
Dad- WD, D17D, D19D, RT100A, 7020, 7080,7580, 2-8550's, 2-S77, HD15
|
|
Larry(OH)
Orange Level
Joined: 11 Sep 2009
Location: Shreve Ohio
Points: 1577
|
Post Options
Thanks(0)
Quote Reply
Posted: 19 Sep 2017 at 7:44am |
|
Shereman is Overdrive or Underdrive. Can be found but pricey. I used a complete rear end out of a speed patrol that is a lower gear like a RC. second gear is about what old first gear was. 1st is low and reverse is slow
|
|
'40 WC puller,'50 WD puller,'50 M puller '65 770 Ollie
*ALLIS EXPRESS contact*
I can explain it to you, BUT I cannot understand it for you!!
|
|
