226 wrist pins

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   For a 226 in a WD45 the wrist pins have to be offset one way or the other so they don’t rub the sleeves according to my manual. 
It is the same way on the D17/170? 
Also should the bolts on the rod that tighten down the wrist pin, should the bolts face away from or towards the cam? I have taken apart a couple of different engines and they were both opposite of each other. My manual also does not specify that so does it even matter? 

	This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
	The Forum	Parts and Services	Unofficial Allis Store	Tractor Shows	Serial Numbers	History

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
PA185 Members Profile Send Private Message Find Members Posts Add to Buddy List Bronze Level Joined: 08 Mar 2019 Location: Pennsylvania Points: 67	Post Options Post Reply Quote PA185 Report Post Thanks(0) Quote Reply Topic: 226 wrist pins Posted: 02 Apr 2021 at 5:45am
	For a 226 in a WD45 the wrist pins have to be offset one way or the other so they don’t rub the sleeves according to my manual. It is the same way on the D17/170? Also should the bolts on the rod that tighten down the wrist pin, should the bolts face away from or towards the cam? I have taken apart a couple of different engines and they were both opposite of each other. My manual also does not specify that so does it even matter?

Sponsored Links

SteveM C/IL Members Profile Send Private Message Find Members Posts Add to Buddy List Orange Level Access Joined: 12 Sep 2009 Location: Shelbyville IL Points: 8244	Post Options Post Reply Quote SteveM C/IL Report Post Thanks(0) Quote Reply Posted: 14 Apr 2021 at 1:33pm
	Been a while...think rods are offset (the beam is not centered over bearing) because of crank/block orientation....so it seems that 1&4 set one direction and 2&3 are opposite. If so 2 clamps will be on cam side and 2 opposite. The beam of rod is closer to cylinder wall on one side which is why the pin can't be centered in rod. You should be able to figure out which is correct after studying it. Don't clamp rod in vise to tighten wrist pin. Clamp one of those tapered/pointed hook bars in vise and stick wrist pin over it.

MACK Members Profile Send Private Message Find Members Posts Add to Buddy List Orange Level Joined: 17 Nov 2009 Points: 7664	Post Options Post Reply Quote MACK Report Post Thanks(0) Quote Reply Posted: 30 May 2021 at 10:27pm
	226, all bolts go to cam. Small engine B c D14 D15 ect. Two one way two the other. MACK