This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Other Topics > Pulling Forum
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


Z CODE ENGINE
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
D17-WD45-WD-WC View Drop Down
Bronze Level
Bronze Level
Avatar

Joined: 14 Aug 2017
Location: Ellsworth WI
Points: 6 		Post Options Post Options   Thanks (0) Thanks(0)   Quote D17-WD45-WD-WC Quote  Post ReplyReply Direct Link To This Post Topic: Z CODE ENGINE
    Posted: 14 Aug 2017 at 10:15pm
In a 226 Z code, can you run a flat top piston. I've heard both yes and no. Don't want to do something to a tractor that can't be undone. Thanks
Back to Top
Sponsored Links


Back to Top
Charlie175 View Drop Down
Orange Level
Orange Level


Joined: 11 Sep 2009
Location: Shenandoah, VA
Points: 6358 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Charlie175 Quote  Post ReplyReply Direct Link To This Post Posted: 15 Aug 2017 at 7:06am
Yes you can.
Best bet would be to run 175 power crater pistons as these gave great performance
Charlie

'48 B, '51 CA, '56 WD45 '61 D17, '63 D12, '65 D10 , '68 One-Ninety XTD
Back to Top
DrAllis View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Points: 20534 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DrAllis Quote  Post ReplyReply Direct Link To This Post Posted: 16 Aug 2017 at 7:25am
Z code engine is already 8.0 to 1 compression ratio. If you want more, flat tops will get you that if ( and only if) the piston pin is located correctly. Just because it's a flat top doesn't mean squat if the pin location is too high up. Any more than 8 to 1 will require higher octane fuel.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.160 seconds.


Help Support the
Unofficial Allis Forum