This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


gaining trans oil on d17 iv
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
Brian NC View Drop Down
Bronze Level
Bronze Level


Joined: 18 Sep 2009
Location: North Carolina
Points: 13 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Brian NC Quote  Post ReplyReply Direct Link To This Post Topic: gaining trans oil on d17 iv
    Posted: 07 Sep 2010 at 8:20pm
I am losing hyd. oil and gaining trans oil. Is there a seal between power director / hyd sump other than trans input shaft seal. Where can i get these parts?
Back to Top
Sponsored Links


Back to Top
ChuckLuedtkeSEWI View Drop Down
Orange Level
Orange Level


Joined: 11 Sep 2009
Location: Jackson, WI
Points: 1826 		Post Options Post Options   Thanks (0) Thanks(0)   Quote ChuckLuedtkeSEWI Quote  Post ReplyReply Direct Link To This Post Posted: 07 Sep 2010 at 8:24pm
I believe there is a seal on the pto shaft that seals between the two compartments.   I'm sure someone else will chime in. 
Back to Top
DSeries4 View Drop Down
Orange Level
Orange Level
Avatar

Joined: 12 Sep 2009
Location: Ontario, Canada
Points: 7379 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DSeries4 Quote  Post ReplyReply Direct Link To This Post Posted: 07 Sep 2010 at 9:50pm
It is the input shaft seal that needs replacing.  AGCO carries them.  You will have to split the tractor - might as well replace the other seals while you are at it.
Back to Top
gcalent View Drop Down
Bronze Level
Bronze Level
Avatar

Joined: 19 May 2010
Location: Willards, Md
Points: 179 		Post Options Post Options   Thanks (0) Thanks(0)   Quote gcalent Quote  Post ReplyReply Direct Link To This Post Posted: 08 Sep 2010 at 9:29am
Your problem is most likely the PTO shaft seals there two of the placed together with the lip in opposite directions. The input shaft is up high enough that little if any oil will gravity through. You can get leakage through the input shaft on tractors with hydraulic power director cluthes, because of worn or broken seal rings.
Pullin With AC
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.078 seconds.


Help Support the
Unofficial Allis Forum