This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


WC steering adjustment???
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
split51 View Drop Down
Orange Level
Orange Level


Joined: 13 Sep 2009
Location: Guthrie, OK
Points: 713 		Post Options Post Options   Thanks (0) Thanks(0)   Quote split51 Quote  Post ReplyReply Direct Link To This Post Topic: WC steering adjustment???
    Posted: 17 Aug 2010 at 1:14pm
  How do you adjust for slack between the worm gear and steering gear on a 35 WC narrow front?

Edited by split51 - 17 Aug 2010 at 5:07pm
Back to Top
Sponsored Links


Back to Top
skipwelte View Drop Down
Orange Level
Orange Level


Joined: 29 Oct 2009
Location: Anthon, Iowa
Points: 723 		Post Options Post Options   Thanks (0) Thanks(0)   Quote skipwelte Quote  Post ReplyReply Direct Link To This Post Posted: 17 Aug 2010 at 2:18pm
Might be the keyway in the bottom where the spindles go on the verticle shaft worn. Also check the looseness in the steering Ujoint.  Thats about it. HTH  good luck
Back to Top
Good View Drop Down
Orange Level
Orange Level
Avatar

Joined: 05 Apr 2010
Location: Logansport IN
Points: 453 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Good Quote  Post ReplyReply Direct Link To This Post Posted: 17 Aug 2010 at 2:19pm
Usually the slop in that is from the pedistal housing the rack shaft goes down through there is no bushing there but you can machine to put one there.the only adjustment up there is to take shims out to tighten worm gear bearings.
B212,716,two 314H's,WC,WD,D19,190XT
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.078 seconds.


Help Support the
Unofficial Allis Forum