This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


G Distributor
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
Bob-Maine View Drop Down
Orange Level
Orange Level
Avatar

Joined: 11 Sep 2009
Location: Central Maine
Points: 922 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Bob-Maine Quote  Post ReplyReply Direct Link To This Post Topic: G Distributor
    Posted: 05 Jun 2010 at 4:45pm
Putting my G back together. There is a square O ring seal on the distributor shaft ( 1" ID and 1/8" section). I should replace it. Anybody know of a good source. McMaster Carr has them in bags of 100.
Bob@allisdowneast
Back to Top
Sponsored Links


Back to Top
Dusty MI View Drop Down
Orange Level
Orange Level
Avatar

Joined: 13 Sep 2009
Location: Charlotte, Mi
Points: 5058 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Dusty MI Quote  Post ReplyReply Direct Link To This Post Posted: 05 Jun 2010 at 6:11pm
Many good hardware stores carry o-rings.

I just looked in my parts book and there is no o-ring shown. There's a seal, part #800316, shown that goes under the clamp. Perhaps it's a regulator o-ring that became flat on the sides from all the years of being squeezed between the block and clamp.

Dusty
917 H, '48 G, '65 D-10 series III "Allis Express"
Back to Top
Bob-Maine View Drop Down
Orange Level
Orange Level
Avatar

Joined: 11 Sep 2009
Location: Central Maine
Points: 922 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Bob-Maine Quote  Post ReplyReply Direct Link To This Post Posted: 05 Jun 2010 at 6:19pm
Thanks, Dusty, but this is a square cross section O ring. I didn't think to look in my parts book. Maybe the seal is the square O ring.

Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.078 seconds.


Help Support the
Unofficial Allis Forum