Farm Equipment - G Distributor

Print Page | Close Window

G Distributor

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=13430
Printed Date: 01 Feb 2025 at 1:51pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: G Distributor

Posted By: Bob-Maine
Subject: G Distributor
Date Posted: 05 Jun 2010 at 4:45pm

Putting my G back together. There is a square O ring seal on the distributor shaft ( 1" ID and 1/8" section). I should replace it. Anybody know of a good source. McMaster Carr has them in bags of 100.
Bob@allisdowneast

Replies:

Posted By: Dusty MI
Date Posted: 05 Jun 2010 at 6:11pm

Many good hardware stores carry o-rings.

I just looked in my parts book and there is no o-ring shown. There's a seal, part #800316, shown that goes under the clamp. Perhaps it's a regulator o-ring that became flat on the sides from all the years of being squeezed between the block and clamp.

Dusty

-------------
917 H, '48 G, '65 D-10 series III "Allis Express"

Posted By: Bob-Maine
Date Posted: 05 Jun 2010 at 6:19pm

Thanks, Dusty, but this is a square cross section O ring. I didn't think to look in my parts book. Maybe the seal is the square O ring.