This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


207430+910324 MIA
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
morton(pa) View Drop Down
Orange Level
Orange Level
Avatar

Joined: 11 Sep 2009
Location: Lancaster, PA
Points: 1234 		Post Options Post Options   Thanks (0) Thanks(0)   Quote morton(pa) Quote  Post ReplyReply Direct Link To This Post Topic: 207430+910324 MIA
    Posted: 04 Apr 2010 at 7:34pm
Yeah, I thought that title might turn a few heads. Anyway, in case you didn't take the time to look them up, I am missing a Clip (90 degree angle one that pulls the mag into the gov.) and one of the nuts to put the magneto back on one of the B's. I "borrowed" a set from a different tractor for now but I will need to replace them at some point. Anyone know of any sources for these parts? Hopefully I can find them because I'm getting the feeling that they might be costly, at least the clip, to replace. Is the nut just a standard or will I need to special order that? Didn't get the time to look.
Back to Top
Sponsored Links


Back to Top
B26240 View Drop Down
Orange Level
Orange Level


Joined: 21 Nov 2009
Location: mn
Points: 3860 		Post Options Post Options   Thanks (0) Thanks(0)   Quote B26240 Quote  Post ReplyReply Direct Link To This Post Posted: 04 Apr 2010 at 7:39pm
morton  I would think you could make the clip out of a piece of flat strap, drill 3/8 hol then put in vice and hammer over to 90* HTH Mark L
Back to Top
morton(pa) View Drop Down
Orange Level
Orange Level
Avatar

Joined: 11 Sep 2009
Location: Lancaster, PA
Points: 1234 		Post Options Post Options   Thanks (0) Thanks(0)   Quote morton(pa) Quote  Post ReplyReply Direct Link To This Post Posted: 04 Apr 2010 at 7:49pm
I've thought about that. I wasn't sure if it would be too precise of a part to do, but I guess it wouldn't hurt to try.
Back to Top
Chalmersbob View Drop Down
Orange Level
Orange Level


Joined: 11 Sep 2009
Location: Pennsylvania
Points: 2122 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Chalmersbob Quote  Post ReplyReply Direct Link To This Post Posted: 04 Apr 2010 at 8:34pm
Morton, You have one to use as apattern. The nut is a standad hardware store item. You need a flat and lock washer also. Bob
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.063 seconds.


Help Support the
Unofficial Allis Forum