This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity. | ||||||
The Forum | Parts and Services | Unofficial Allis Store | Tractor Shows | Serial Numbers | History |
WD45 |
Post Reply |
Author | |
smokey
Orange Level Joined: 04 Oct 2010 Location: Michigan Points: 287 |
Post Options
Thanks(0)
Posted: 14 Jan 2012 at 6:49am |
I picked this tractor up 4 or 5 yrs ago and she was tired, saved it from going to the junk hope to get some Pic's of it on here as work progess go's along, it's a tough looking old wd45 ser#234678 beleive a 1956, 4 bolt wide front, I have been picking up a part here and there, So I think have enough to work on her and maybe bring here to life!
I'll surely be asking for HELP on this one as I go along, My nephew said last night WOW you'll have your work cut out on this one as we loaded it on the trailer at Dads to bring it to my place.
|
|
Sponsored Links | |
JayIN
Orange Level Joined: 18 Dec 2009 Location: SE/IN Points: 1982 |
Post Options
Thanks(0)
|
Best of luck! You will be glad you did it when its over!
|
|
sometimes I walk out to my shop and look around and think "Who's the idiot that owns this place?"
|
|
Ted J
Orange Level Joined: 05 Jul 2010 Location: La Crosse, WI Points: 18849 |
Post Options
Thanks(0)
|
GOOD LUCK and this is the spot to ask, as you know.
|
|
"Allis-Express"
19?? WC / 1941 C / 1952 CA / 1956 WD45 / 1957 WD45 / 1958 D-17 |
|
smokey
Orange Level Joined: 04 Oct 2010 Location: Michigan Points: 287 |
Post Options
Thanks(0)
|
Is there sealing O-rings on the sleaves on a 45 engine Like that on a 301 ?
|
|
ctbowles58
Orange Level Joined: 17 Jun 2011 Location: Clarksville, MO Points: 2249 |
Post Options
Thanks(0)
|
|
|
smokey
Orange Level Joined: 04 Oct 2010 Location: Michigan Points: 287 |
Post Options
Thanks(0)
|
Ok I got Started working on the WD45, Here is some Pic's I was going to just pull the old Engine and put in one that already runs, but this one wasn't as bad as I thought it would be, Already has M&W kit in it so I'am going to run some of the pic's then ask some Qustions on the last couple pic's.
Now I need to know if the flywheel will make it with these cracks? the clutch plates it self looked to be fairly new.
And last but least crank looks fine and has been redone, but I believe the bearings are 30 over, this was what I found on the bearing.
DAB 72
67-25
7440=T
030
and I'am going put in new bearings.
|
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |