WD45
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=43746
Printed Date: 16 Dec 2024 at 4:52pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: WD45
Posted By: smokey
Subject: WD45
Date Posted: 14 Jan 2012 at 6:49am
|
I picked this tractor up 4 or 5 yrs ago and she was tired, saved it from going to the junk hope to get some Pic's of it on here as work progess go's along, it's a tough looking old wd45 ser#234678 beleive a 1956, 4 bolt wide front, I have been picking up a part here and there, So I think have enough to work on her and maybe bring here to life!
I'll surely be asking for HELP on this one as I go along, My nephew said last night WOW you'll have your work cut out on this one as we loaded it on the trailer at Dads to bring it to my place.
|
Replies:
Posted By: JayIN
Date Posted: 14 Jan 2012 at 7:44am
|
Best of luck! You will be glad you did it when its over! ------------- sometimes I walk out to my shop and look around and think "Who's the idiot that owns this place?" |
Posted By: Ted J
Date Posted: 14 Jan 2012 at 11:29am
|
GOOD LUCK and this is the spot to ask, as you know.
------------- "Allis-Express" 19?? WC / 1941 C / 1952 CA / 1956 WD45 / 1957 WD45 / 1958 D-17 |
Posted By: smokey
Date Posted: 14 Jan 2012 at 3:21pm
| Is there sealing O-rings on the sleaves on a 45 engine Like that on a 301 ? |
Posted By: ctbowles58
Date Posted: 14 Jan 2012 at 4:27pm
|
smokey wrote:Posted By: smokey
Date Posted: 15 Jan 2012 at 7:54pm
|
Ok I got Started working on the WD45, Here is some Pic's I was going to just pull the old Engine and put in one that already runs, but this one wasn't as bad as I thought it would be, Already has M&W kit in it so I'am going to run some of the pic's then ask some Qustions on the last couple pic's.
    Now I need to know if the flywheel will make it with these cracks? the clutch plates it self looked to be fairly new.
 And last but least crank looks fine and has been redone, but I believe the bearings are 30 over, this was what I found on the bearing.
DAB 72
67-25
7440=T
030
and I'am going put in new bearings.
   |