This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


Marvel Schebler TSX464

 Post Reply Post Reply
Author
Message
deereequipment1 View Drop Down
Orange Level
Orange Level
Avatar

Joined: 31 Mar 2011
Location: Southern MD
Points: 261
Post Options Post Options   Thanks (0) Thanks(0)   Quote deereequipment1 Quote  Post ReplyReply Direct Link To This Post Topic: Marvel Schebler TSX464
    Posted: 02 May 2011 at 3:26pm
Hey there.

My WD45 won't run without the choke being half on.
I've had the tractor for a few weeks, and tried cleaning out the main jetm but it didn't help.

This tractor actually has a LeRoi D201 engine, no thermostat, and just won't run properly. The choke actually has to run about 60% on, and have tried adjusting the two jets, but they don't seem to improve where the choke needs to be.

Any suggestions?
 
Back to Top
Sponsored Links


Back to Top
deereequipment1 View Drop Down
Orange Level
Orange Level
Avatar

Joined: 31 Mar 2011
Location: Southern MD
Points: 261
Post Options Post Options   Thanks (0) Thanks(0)   Quote deereequipment1 Quote  Post ReplyReply Direct Link To This Post Posted: 02 May 2011 at 3:34pm
The carb adjustment sheet says adjustments shouldn't be made until the engine is at operating temperature, and the choke is wide open.

Well.......with no thermostat, I can't get to operating temp, and with the choke wide open, the tractor shuts off.

Suggestions?????

LeRoi folks, any suggestions?
My 2 port water manifold has no thermostat housing built into it.
I have another manifold off another tractor, that I could install, but I'm not sure if this LeRoi is suppose to operate without a thermostat.

Back to Top
deereequipment1 View Drop Down
Orange Level
Orange Level
Avatar

Joined: 31 Mar 2011
Location: Southern MD
Points: 261
Post Options Post Options   Thanks (0) Thanks(0)   Quote deereequipment1 Quote  Post ReplyReply Direct Link To This Post Posted: 02 May 2011 at 3:57pm
OK, I just pulled off the smaller Zenith carb that was on an old WD that has been sitting (inside) for 12 years. My tractor fired right up, and runs great. So now I know its a carb issue.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.078 seconds.


Help Support the
Unofficial Allis Forum