This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


allis chambers disk
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
hgreen View Drop Down
Bronze Level
Bronze Level
Avatar

Joined: 21 Feb 2011
Points: 5 		Post Options Post Options   Thanks (0) Thanks(0)   Quote hgreen Quote  Post ReplyReply Direct Link To This Post Topic: allis chambers disk
    Posted: 25 Apr 2011 at 8:35pm

Have been looking for bearing and bearing housing for heavy duty Model 200 disk.  The one I have is the 8' model but has the heavier duty bearing housing and bearing.  The axle is square and is approximately 1  1/8 in. in diameter and the bearing diameter appears to be approx 3  1/8 in.  
Back to Top
Sponsored Links


Back to Top
SHAMELESS View Drop Down
Orange Level
Orange Level
Avatar

Joined: 13 Sep 2009
Location: EAST NE
Points: 29486 		Post Options Post Options   Thanks (0) Thanks(0)   Quote SHAMELESS Quote  Post ReplyReply Direct Link To This Post Posted: 25 Apr 2011 at 10:18pm
think IH uses the same thing, i was able to match the bearings on my 2600 disk. 
Back to Top
hgreen View Drop Down
Bronze Level
Bronze Level
Avatar

Joined: 21 Feb 2011
Points: 5 		Post Options Post Options   Thanks (0) Thanks(0)   Quote hgreen Quote  Post ReplyReply Direct Link To This Post Posted: 26 Apr 2011 at 8:12pm


Thanks for the feedback, I'll check into that.
Back to Top
hgreen View Drop Down
Bronze Level
Bronze Level
Avatar

Joined: 21 Feb 2011
Points: 5 		Post Options Post Options   Thanks (0) Thanks(0)   Quote hgreen Quote  Post ReplyReply Direct Link To This Post Posted: 28 Apr 2011 at 9:25pm

I've found the bearing, NTN makes one that matches the ones on the disk, but they don't make a housing for it.  PEER bearing makes a housing (called Tillage Trunnion Unit), but they only make one with an axle diameter of 1.5" which is too large.  The axle on my disk is about 1 1/8 " and the housing is 4 inches.  Does anyone on the forum have a housing which will work with the bearing.
Back to Top
Wes (VA) View Drop Down
Orange Level
Orange Level


Joined: 12 Sep 2009
Location: Elkton, VA
Points: 510 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Wes (VA) Quote  Post ReplyReply Direct Link To This Post Posted: 29 Apr 2011 at 11:21pm
Have you looked at shoup?  here's a bearing from a Kewanee disc like we run.   http://www.shoupparts.com/DS208-TTR8/     -Wes
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.063 seconds.


Help Support the
Unofficial Allis Forum