Farm Equipment - allis chambers disk

Print Page | Close Window

allis chambers disk

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=29759
Printed Date: 04 Mar 2025 at 10:23pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: allis chambers disk

Posted By: hgreen
Subject: allis chambers disk
Date Posted: 25 Apr 2011 at 8:35pm

Have been looking for bearing and bearing housing for heavy duty Model 200 disk. The one I have is the 8' model but has the heavier duty bearing housing and bearing. The axle is square and is approximately 1 1/8 in. in diameter and the bearing diameter appears to be approx 3 1/8 in.

Replies:

Posted By: SHAMELESS
Date Posted: 25 Apr 2011 at 10:18pm

think IH uses the same thing, i was able to match the bearings on my 2600 disk.

Posted By: hgreen
Date Posted: 26 Apr 2011 at 8:12pm

Thanks for the feedback, I'll check into that.

Posted By: hgreen
Date Posted: 28 Apr 2011 at 9:25pm

I've found the bearing, NTN makes one that matches the ones on the disk, but they don't make a housing for it. PEER bearing makes a housing (called Tillage Trunnion Unit), but they only make one with an axle diameter of 1.5" which is too large. The axle on my disk is about 1 1/8 " and the housing is 4 inches. Does anyone on the forum have a housing which will work with the bearing.

Posted By: Wes (VA)
Date Posted: 29 Apr 2011 at 11:21pm

Have you looked at shoup? here's a bearing from a Kewanee disc like we run. http://www.shoupparts.com/DS208-TTR8/ - http://www.shoupparts.com/DS208-TTR8/ -Wes