185 Ignition Switch Replacement

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   Need to replace the Ignition Switch on my 185. I removed the sheetmetal shroud on top of the hood and was able to determine with a test light that I'm not getting any power from the BAT side to the IGN side of the switch in the "on" position which causes no power to the push button start switch. The service manual does not cover removing the Instrument Panel. What all do I need to do/remove to gain access to the back of the Instrument Panel?? Does the large sheetmetal cover directly in front of the gear shift need to removed??
Thanx for your help.
Chris

	This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
	The Forum	Parts and Services	Unofficial Allis Store	Tractor Shows	Serial Numbers	History

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
ChrisS Members Profile Send Private Message Find Members Posts Add to Buddy List Bronze Level Joined: 10 Mar 2016 Location: St Marks, KS Points: 63	Post Options Post Reply Quote ChrisS Report Post Thanks(0) Quote Reply Topic: 185 Ignition Switch Replacement Posted: 3 hours 24 minutes ago at 5:08pm
	Need to replace the Ignition Switch on my 185. I removed the sheetmetal shroud on top of the hood and was able to determine with a test light that I'm not getting any power from the BAT side to the IGN side of the switch in the "on" position which causes no power to the push button start switch. The service manual does not cover removing the Instrument Panel. What all do I need to do/remove to gain access to the back of the Instrument Panel?? Does the large sheetmetal cover directly in front of the gear shift need to removed?? Thanx for your help. Chris

Sponsored Links

Fred in Pa Members Profile Send Private Message Find Members Posts Add to Buddy List Orange Level Joined: 13 Sep 2009 Location: Hanover Pa. Points: 9206	Post Options Post Reply Quote Fred in Pa Report Post Thanks(0) Quote Reply Posted: 1 hour 27 minutes ago at 7:05pm
	Just remove top cover only. This is how I do them . I get all wires put on switch and then reinstall. also put eyelets on push button switch ,pull it out do the wires and put it back in. I also replace ends on switch wires Edited by Fred in Pa - 1 hour 20 minutes ago at 7:12pm
	He who dies with the most toys is, nonetheless ,still dead. If all else fails ,Read all that is PRINTED.

KJCHRIS Members Profile Send Private Message Find Members Posts Add to Buddy List Orange Level Joined: 21 Dec 2015 Location: WC Iowa Points: 896	Post Options Post Reply Quote KJCHRIS Report Post Thanks(0) Quote Reply Posted: 37 minutes ago at 7:55pm
	You've got the cover over the top/rear of instrument panel off? Get a new OEM style replacement switch. Remove negative battery cables from batt posts. All you need do is remove the outer nut that holds switch in place, move switch back out of hole so is easier to get to terminals. Move wires 1 at a time from old to new switches, slide new switch into hole in dash, install & tighten nut, reinstall cover. Be careful not to strip the nut or the screws holding the cover in place.
	AC 200, CAH, AC185D bareback, AC 180D bareback, D17 III, WF. D17 Blackbar grill, NF. D15 SFW. Case 1175 CAH, Bobcat 543B,