Print Page | Close Window

185 Ignition Switch Replacement

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=203893
Printed Date: 29 Oct 2024 at 10:23pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com


Topic: 185 Ignition Switch Replacement
Posted By: ChrisS
Subject: 185 Ignition Switch Replacement
Date Posted: 29 Oct 2024 at 5:08pm
Need to replace the Ignition Switch on my 185. I removed the sheetmetal shroud on top of the hood and was able to determine with a test light that I'm not getting any power from the BAT side to the IGN side of the switch in the "on" position which causes no power to the push button start switch. The service manual does not cover removing the Instrument Panel. What all do I need to do/remove to gain access to the back of the Instrument Panel?? Does the large sheetmetal cover directly in front of the gear shift need to removed??

Thanx for your help.
Chris



Replies:
Posted By: Fred in Pa
Date Posted: 29 Oct 2024 at 7:05pm

 Just remove top cover only.    This is how I do them .
 I get all wires put on switch and then reinstall. also put eyelets on push button switch ,pull it out do the wires and put it back in. 
   
 I also replace ends on switch wires








-------------
He who dies with the most toys is,
nonetheless ,still dead.
If all else fails ,Read all that is PRINTED.


Posted By: KJCHRIS
Date Posted: 29 Oct 2024 at 7:55pm
You've got the cover over the top/rear of instrument panel off? 
 Get a new OEM style replacement switch.  
 Remove negative battery cables from batt posts. 
 All you need do is remove the outer nut that holds switch in place, move switch back out of hole so is easier to get to terminals. Move wires 1 at a time from old to new switches, slide new switch into hole in dash, install & tighten nut, reinstall cover. Be careful not to strip the nut or the screws holding the cover in place. 


-------------
AC 200, CAH, AC185D bareback, AC 180D bareback, D17 III, WF. D17 Blackbar grill, NF. D15 SFW. Case 1175 CAH, Bobcat 543B,



Print Page | Close Window

Forum Software by Web Wiz Forums® version 11.10 - http://www.webwizforums.com
Copyright ©2001-2017 Web Wiz Ltd. - https://www.webwiz.net