This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


7040 clutch not disengaging
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
Mattman View Drop Down
Bronze Level
Bronze Level


Joined: 20 Dec 2012
Location: Plover, WI
Points: 174 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Mattman Quote  Post ReplyReply Direct Link To This Post Topic: 7040 clutch not disengaging
    Posted: 19 Oct 2024 at 4:54pm
I went out to chop stalks in my power shift 7040 today and tractor wants to keep moving with clutch depressed. I have to go almost to trans brake to get it to disengage, then it stops hard if I go too far. This is a power shift so no clutch cable. Just wondering if there is an easy fix or is this will this cause me a “splitting headache”?
Back to Top
Sponsored Links


Back to Top
DrAllis View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Points: 20521 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DrAllis Quote  Post ReplyReply Direct Link To This Post Posted: 19 Oct 2024 at 5:30pm
Stepping on the inching pedal must make the shift lever go fully into 4th gear position or the tractor will not stop moving.
Back to Top
Mattman View Drop Down
Bronze Level
Bronze Level


Joined: 20 Dec 2012
Location: Plover, WI
Points: 174 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Mattman Quote  Post ReplyReply Direct Link To This Post Posted: 19 Oct 2024 at 5:39pm
She drops to 4th but still pulls a bit with clutch down
Back to Top
DrAllis View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Points: 20521 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DrAllis Quote  Post ReplyReply Direct Link To This Post Posted: 19 Oct 2024 at 5:56pm
When not "pulling" a load, when the inching pedal is depressed just down to the brake zone, at FULL throttle, it takes the transmission about 2 seconds to release. 5th and 6th gear much worse than 1-2-or 3. I doubt that there's anything wrong. You just ain't used to the quirks of a Power Shift tranny. If you are using 6th gear, switch to 2nd gear high range.
Back to Top
Mattman View Drop Down
Bronze Level
Bronze Level


Joined: 20 Dec 2012
Location: Plover, WI
Points: 174 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Mattman Quote  Post ReplyReply Direct Link To This Post Posted: 19 Oct 2024 at 6:02pm
Most of this was happening in 5th high going to the field. Intersections were kind of sketchy. I really had to throttle her down.
Back to Top
DrAllis View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Points: 20521 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DrAllis Quote  Post ReplyReply Direct Link To This Post Posted: 19 Oct 2024 at 6:29pm
Throttling down works best. The Power Shift isn't made to roll up to a stop sign at full throttle and depress on the inching pedal to stop. And also really not made to restart motion at full throttle in 4th gear. Shift to third and start out about 1500 RPM, increase engine speed some and start progressively up shifting one gear at a time.
Back to Top
NEVER green View Drop Down
Orange Level Access
Orange Level Access


Joined: 28 Feb 2013
Location: MN.
Points: 7498 		Post Options Post Options   Thanks (0) Thanks(0)   Quote NEVER green Quote  Post ReplyReply Direct Link To This Post Posted: 20 Oct 2024 at 8:56am
Originally posted by Mattman Mattman wrote:

Most of this was happening in 5th high going to the field. Intersections were kind of sketchy. I really had to throttle her down.

  If I have to come to a complete stop I slam it into neutral  coast to a stop.
2-8050 1-7080 6080 D-19 modelE & A 7040   R50       
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.094 seconds.


Help Support the
Unofficial Allis Forum