This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


7010 Transmission Problem
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
crossfire879 View Drop Down
Bronze Level
Bronze Level


Joined: 28 Sep 2023
Location: NA
Points: 2 		Post Options Post Options   Thanks (0) Thanks(0)   Quote crossfire879 Quote  Post ReplyReply Direct Link To This Post Topic: 7010 Transmission Problem
    Posted: 28 Sep 2023 at 5:55pm
I have a 7010 with the 12 speed transmission. I am unable to get into any other gear except for 3rd and reverse because the "throw" of the gear shifter is too much. For example when coming from reverse or 3rd into neutral, you have to have the shifter all the way ahead (where 1,2,4 would be) to be in neutral. Therefore its unable to go into those top gears. The linkage above the floor all seems tight. Also it just started to occasionally pop out of gear. Is there anything else I can check?
Back to Top
Sponsored Links


Back to Top
DrAllis View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Points: 20479 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DrAllis Quote  Post ReplyReply Direct Link To This Post Posted: 28 Sep 2023 at 6:25pm
What is the largest number on your tee handle shifter?? 4 or 5.  You have either a 16-speed or 20-speed Power Director transmission. There is linkage inside the console that you must take the console side panel off (next to the seat) to see. There is linkage under the cab too. Something is very loose and it would take two people to find the problem. There could be a broken bolt holding one of the pivot bearings under the cab floor. There are two of those.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.047 seconds.


Help Support the
Unofficial Allis Forum