This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


B rear splined axle
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
TMiller/NC View Drop Down
Orange Level Access
Orange Level Access


Joined: 11 Sep 2009
Location: Lenoir, NC
Points: 1775 		Post Options Post Options   Thanks (0) Thanks(0)   Quote TMiller/NC Quote  Post ReplyReply Direct Link To This Post Topic: B rear splined axle
    Posted: 04 Oct 2010 at 4:47pm

Has anyone repaired the splines by building up with wire welder and turning back and re-cutting the splines in a milling mach?  Will the axle become to hard to work?  Will it become brittle or stress crack?    Thanks,  Tim
Back to Top
Sponsored Links


Back to Top
Rick of HopeIN View Drop Down
Orange Level
Orange Level
Avatar

Joined: 11 Sep 2009
Location: Hope, Indiana
Points: 1324 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Rick of HopeIN Quote  Post ReplyReply Direct Link To This Post Posted: 04 Oct 2010 at 5:02pm
I just stuffed in some aluminum shims,  OK so far.  I have heard that it is usually the hub, not the shaft that gets beat up.
1951 B, 1937 WC, 1957 D14, -- Thanks and God Bless
Back to Top
DrAllis View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Points: 20980 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DrAllis Quote  Post ReplyReply Direct Link To This Post Posted: 04 Oct 2010 at 5:12pm
I patched one once by grinding off the back side of the hub ( with a hand held grinder) so it would go on farther and added a washer on the outside behind the nut. Just depends how worn things are and I agree, the cast hub is probably worn more than the shaft.
Back to Top
TMiller/NC View Drop Down
Orange Level Access
Orange Level Access


Joined: 11 Sep 2009
Location: Lenoir, NC
Points: 1775 		Post Options Post Options   Thanks (0) Thanks(0)   Quote TMiller/NC Quote  Post ReplyReply Direct Link To This Post Posted: 04 Oct 2010 at 5:58pm
Dr Allis, is the hub cast iron or a weldable malleable ?  Thanks,  Tim
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.098 seconds.


Help Support the
Unofficial Allis Forum