This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


226 Pan Gasket
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
Claus View Drop Down
Orange Level
Orange Level
Avatar

Joined: 09 Dec 2009
Location: Hebron In
Points: 1152 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Claus Quote  Post ReplyReply Direct Link To This Post Topic: 226 Pan Gasket
    Posted: 15 Jul 2010 at 12:46pm
Who makes the best oil pan gasket for the 226?  Need one!
Back to Top
Sponsored Links


Back to Top
joshjohndeere View Drop Down
Silver Level
Silver Level
Avatar

Joined: 22 May 2010
Location: nebraska
Points: 73 		Post Options Post Options   Thanks (0) Thanks(0)   Quote joshjohndeere Quote  Post ReplyReply Direct Link To This Post Posted: 17 Jul 2010 at 8:26pm
felpro  makes a good cork gasket and i will give u a bit of advice if u are putting it in an engine still in the tractor roll your from and rear main pieces in a tight circle and hold like that with a rubber band then soak them in a cup of water overnight. this makes them swell alittle and more pliable. then position on the pan and on the outsideof the pan stick needle in the gasket to center it. put the pan and gasket up and bolt down, pull your pins and its all good.
Back to Top
Dave(inMA) View Drop Down
Orange Level
Orange Level
Avatar

Joined: 12 Sep 2009
Location: Grafton, MA
Points: 2398 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Dave(inMA) Quote  Post ReplyReply Direct Link To This Post Posted: 17 Jul 2010 at 8:38pm
Now that sounds like a good process, josh. Oughta work on any of those gasket sets. I've seen the "curl overnight" suggestion before but you've added a couple of good ideas.
WC, CA, D14, WD45
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.047 seconds.


Help Support the
Unofficial Allis Forum