Allis C steering

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   In the process of rebuilding the steering on the Model C with Woods L59 mower.  There is excessive wear on the steering link ball joints between the gear box and the front pedestal.  Does anybody sell this link, or can I go to a cheaper route and weld tie rods from a car onto the shaft, keeping the length the same.  Does anybody know how to measure the taper to compare a vehicle cross reference.  I know it will be tough to find a similar vehicle tie rod joint because the clearances will be tight. 

	This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
	The Forum	Parts and Services	Unofficial Allis Store	Tractor Shows	Serial Numbers	History

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
Boomer Members Profile Send Private Message Find Members Posts Add to Buddy List Bronze Level Joined: 13 Sep 2009 Location: Mid Missouri Points: 102	Post Options Post Reply Quote Boomer Report Post Thanks(0) Quote Reply Topic: Allis C steering Posted: 24 Nov 2010 at 11:11am
	In the process of rebuilding the steering on the Model C with Woods L59 mower. There is excessive wear on the steering link ball joints between the gear box and the front pedestal. Does anybody sell this link, or can I go to a cheaper route and weld tie rods from a car onto the shaft, keeping the length the same. Does anybody know how to measure the taper to compare a vehicle cross reference. I know it will be tough to find a similar vehicle tie rod joint because the clearances will be tight.

Sponsored Links

pumpkin man Members Profile Send Private Message Find Members Posts Add to Buddy List Silver Level Joined: 10 Apr 2010 Location: Michigan Points: 106	Post Options Post Reply Quote pumpkin man Report Post Thanks(0) Quote Reply Posted: 25 Nov 2010 at 6:50pm
	A few years ago at a show had a ( C ) that had redone nice job noticed that the draglink had greaseable ends talked to the man about them he said they were Ford Granada tie rod ends pin had the same taper had them cut and welded on who ever did it did a nice job