220 injection pump shaft

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   I believe I have found the correct injection pump drive shaft for the 220. It is stamped with the number 16063. This engine had a DB pump with tang drive shaft in it and I've been searching parts to get the correct setup. There is a difference in the depth of the hole for the thrust button and spring between the tang shaft and splined shaft. Button and spring I took out has a combined length of 2.055. When set in the shaft, the button sits around .110 deeper in the splined shaft. 
There is no number on the button. How far should the button protrude from the end of the shaft? If it is correct for the tang shaft, can I machine a spacer to put down in the splined shaft to bring it up to proper height?

	This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
	The Forum	Parts and Services	Unofficial Allis Store	Tractor Shows	Serial Numbers	History

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
JM185 Members Profile Send Private Message Find Members Posts Add to Buddy List Bronze Level Joined: 14 Jun 2023 Location: Ohio Points: 30	Post Options Post Reply Quote JM185 Report Post Thanks(0) Quote Reply Topic: 220 injection pump shaft Posted: 15 hours 17 minutes ago at 9:24pm
	I believe I have found the correct injection pump drive shaft for the 220. It is stamped with the number 16063. This engine had a DB pump with tang drive shaft in it and I've been searching parts to get the correct setup. There is a difference in the depth of the hole for the thrust button and spring between the tang shaft and splined shaft. Button and spring I took out has a combined length of 2.055. When set in the shaft, the button sits around .110 deeper in the splined shaft. There is no number on the button. How far should the button protrude from the end of the shaft? If it is correct for the tang shaft, can I machine a spacer to put down in the splined shaft to bring it up to proper height?

Sponsored Links

DrAllis Members Profile Send Private Message Find Members Posts Add to Buddy List Orange Level Access Joined: 12 Sep 2009 Points: 21112	Post Options Post Reply Quote DrAllis Report Post Thanks(0) Quote Reply Posted: 14 hours 52 minutes ago at 9:49pm
	What you cannot have is a bottoming out of the spring when you install the cover over the gear. Lay a straight edge against the button and test for this. I guess you'd probably want near max pressure the spring can provide WITHOUT bottoming out.