This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


CA axle play
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
UPBUSHMIKE View Drop Down
Bronze Level
Bronze Level


Joined: 26 Jul 2023
Location: Yooper
Points: 45 		Post Options Post Options   Thanks (0) Thanks(0)   Quote UPBUSHMIKE Quote  Post ReplyReply Direct Link To This Post Topic: CA axle play
    Posted: 09 Mar 2024 at 11:12am
While fitting tire chains, I noticed one axle on my CA has about 1/4” of lateral play no radial play or bearing noise. Any thoughts on the culprit? Looking at the parts manual, it seems that missing shims or the loosened capscrew could cause this play? Where do I find actual part numbers for the CA?
Back to Top
Sponsored Links


Back to Top
tbran View Drop Down
Orange Level
Orange Level


Joined: 14 Sep 2009
Location: Paris Tn
Points: 3294 		Post Options Post Options   Thanks (0) Thanks(0)   Quote tbran Quote  Post ReplyReply Direct Link To This Post Posted: 09 Mar 2024 at 12:40pm
Remove the cap on the inside of the final drive - locate the center bolt and loosen - under the special washer there are shims.  Removing some or all of them MIGHT take out the play if there is no other issue other than 60 years of wear and tear... Tightening the capscrew will pull the axle in on the inner brg and set the rolling torque needed. 
When told "it's not the money,it's the principle", remember, it's always the money..
Back to Top
Skip, W.Pa View Drop Down
Bronze Level
Bronze Level


Joined: 09 Dec 2020
Location: Mars Pa.
Points: 19 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Skip, W.Pa Quote  Post ReplyReply Direct Link To This Post Posted: 09 Mar 2024 at 6:58pm
tbran is correct. I would not run until you look at it under the cap. A 1/4 inch is a lot of end play ! Hopefully the nut is just backed off and needs adjusted and locked. You may have a bearing that has failed . Is the seal leaking and is there oil in the final drive?
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.063 seconds.


Help Support the
Unofficial Allis Forum