This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


WD45 Starter
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
Mark (ECIN) View Drop Down
Bronze Level
Bronze Level


Joined: 13 Mar 2024
Location: Hagerstown, Ind
Points: 32 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Mark (ECIN) Quote  Post ReplyReply Direct Link To This Post Topic: WD45 Starter
    Posted: 17 hours 26 minutes ago at 4:21pm
How is the starter held on.  Mine is loose,  you can wiggle it around where it goes into the block.

When you start the tractor it moves.
Back to Top
Sponsored Links


Back to Top
dr p View Drop Down
Orange Level
Orange Level


Joined: 24 Feb 2019
Location: new york
Points: 1687 		Post Options Post Options   Thanks (0) Thanks(0)   Quote dr p Quote  Post ReplyReply Direct Link To This Post Posted: 15 hours 4 minutes ago at 6:43pm
Should be frictional fit in the housing with a set screw on the side
Back to Top
Alberta Phil View Drop Down
Orange Level
Orange Level
Avatar

Joined: 13 Sep 2009
Location: Alberta, Canada
Points: 4023 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Alberta Phil Quote  Post ReplyReply Direct Link To This Post Posted: 15 hours 1 minutes ago at 6:46pm
There is a set bolt with a lock nut on the left hand side of the bell housing where the starter mounts. Loosen the lock nut and tighten the set bolt.  It has a tapered end and fits into a corresponding tapered hole in the nose of the starter.  Make sure that the bolt taper is in the hole and tight, as that is your main source of grounding for the starter.

Edited by Alberta Phil - 15 hours 1 minutes ago at 6:46pm
Back to Top
Mark (ECIN) View Drop Down
Bronze Level
Bronze Level


Joined: 13 Mar 2024
Location: Hagerstown, Ind
Points: 32 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Mark (ECIN) Quote  Post ReplyReply Direct Link To This Post Posted: 1 hour 46 minutes ago at 8:01am
Thanks guys.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.055 seconds.


Help Support the
Unofficial Allis Forum