This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Garden Tractors
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


720 seat is too low?
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
Herb(GA) View Drop Down
Orange Level Access
Orange Level Access


Joined: 15 Sep 2009
Location: United States
Points: 1036 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Herb(GA) Quote  Post ReplyReply Direct Link To This Post Topic: 720 seat is too low?
    Posted: 04 Oct 2015 at 12:17pm
If the seat on our recently acquired 720 was several inches higher my opinion is dismounting would be easier and operator's vision may be improved.  Nothing in that area appears to have been modified (lowered).  At first glance such change appears to be readily doable; sorta like 'too good to be true'.
Would appreciate suggestions, and especially anyone's knowledge of experience on this subject. Herb(GA)
Back to Top
Sponsored Links


Back to Top
Steve in NJ View Drop Down
Orange Level Access
Orange Level Access
Avatar

Joined: 12 Sep 2009
Location: Andover, NJ
Points: 11798 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Steve in NJ Quote  Post ReplyReply Direct Link To This Post Posted: 04 Oct 2015 at 7:43pm
Herb,
The only thing I could think of to raise the seat is put a spacer bar (like a piece of square tubing) under the seat front and rear where it bolts to the transmission. I just installed my new seat on my 620, and there's only 4 bolts that hold it to the tranny. The bolt holes in the seat frame are slotted a little bit to.  HTH
Steve@B&B
39'RC, 43'WC, 48'B, 49'G, 50'WF, 65 Big 10, 67'B-110, 75'716H, 2-620's, & a Motorhead wife
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.061 seconds.


Help Support the
Unofficial Allis Forum