This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


XT questions
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
DSeries4 View Drop Down
Orange Level
Orange Level
Avatar

Joined: 12 Sep 2009
Location: Ontario, Canada
Points: 7505 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DSeries4 Quote  Post ReplyReply Direct Link To This Post Topic: XT questions
    Posted: 20 Nov 2011 at 9:30pm
After not being used for a while, my series I 190XT diesel needs ether to get it going.  Once it has been running, it will start no problem.  I have not checked the fuel lines yet.  Just wondering if it could be a weak injector pump, or low compression in the engine.  Any other ideas?
 
Also, the rear axle seal is leaking pretty good on the right side (oil drips on the rim).  Can it be replaced without removing the cast wheel center?  It doesn't sound like it will be easy!  But I welcome any ideas that you may have.
 
Thanks!
'49 G, '54 WD45, '55 CA, '56 WD45D, '57 WD45, '58 D14, '59 D14, '60 D14, '63 D15D, '66 D15II, '66 D21II, '67 D17IV, '67 D17IVD, '67 190XTD, '73 620, '76 185, '77 175, '84 8030, '85 6080
Back to Top
Sponsored Links


Back to Top
Hurst View Drop Down
Orange Level
Orange Level


Joined: 11 Sep 2009
Location: Midway, Ky
Points: 1218 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Hurst Quote  Post ReplyReply Direct Link To This Post Posted: 20 Nov 2011 at 9:38pm
Not sure about the fuel pump, but the axle seal requires the removal of the cast center from the axle.  Not too bad if the wedge is not stuck and you have pusher bolts.

Hurst
1979 Allis Chalmers 7000
5800 Hours
Back to Top
Matt MN View Drop Down
Orange Level
Orange Level
Avatar

Joined: 14 Sep 2009
Location: Silver lake MN
Points: 1491 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Matt MN Quote  Post ReplyReply Direct Link To This Post Posted: 21 Nov 2011 at 8:11am
the next time you try to start it, Pump up the primer pump first to see if that helps. If that helps then you need a new primer pump kit. Agco part # 74063231
Unless your are the lead horse the scenery never changes!!
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.113 seconds.


Help Support the
Unofficial Allis Forum