Farm Equipment - XT questions

Print Page | Close Window

XT questions

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=40875
Printed Date: 08 Sep 2025 at 3:16pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: XT questions

Posted By: DSeries4
Subject: XT questions
Date Posted: 20 Nov 2011 at 9:30pm

After not being used for a while, my series I 190XT diesel needs ether to get it going. Once it has been running, it will start no problem. I have not checked the fuel lines yet. Just wondering if it could be a weak injector pump, or low compression in the engine. Any other ideas?

Also, the rear axle seal is leaking pretty good on the right side (oil drips on the rim). Can it be replaced without removing the cast wheel center? It doesn't sound like it will be easy! But I welcome any ideas that you may have.

Thanks!

-------------
'49 G, '54 WD45, '55 CA, '56 WD45D, '57 WD45, '58 D14, '59 D14, '60 D14, '63 D15D, '66 D15II, '66 D21II, '67 D17IV, '67 D17IVD, '67 190XTD, '73 620, '76 185, '77 175, '84 8030, '85 6080

Replies:

Posted By: Hurst
Date Posted: 20 Nov 2011 at 9:38pm

Not sure about the fuel pump, but the axle seal requires the removal of the cast center from the axle. Not too bad if the wedge is not stuck and you have pusher bolts.

Hurst

-------------
1979 Allis Chalmers 7000
5800 Hours

Posted By: Matt MN
Date Posted: 21 Nov 2011 at 8:11am

the next time you try to start it, Pump up the primer pump first to see if that helps. If that helps then you need a new primer pump kit. Agco part # 74063231

-------------
Unless your are the lead horse the scenery never changes!!