This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


D17 ignition coil

 Post Reply Post Reply
Author
Message
Nathan (SD) View Drop Down
Orange Level
Orange Level


Joined: 11 Sep 2009
Location: Day County SD
Points: 1262
Post Options Post Options   Thanks (0) Thanks(0)   Quote Nathan (SD) Quote  Post ReplyReply Direct Link To This Post Topic: D17 ignition coil
    Posted: 24 Aug 2024 at 10:33pm
D17 fried a coil a few days ago. Died in the yard and didn’t deal with it until the next day because I thought it ran out of gas. Turns out the coil was dead. Replaced it with one I had in stock from another tractor. Today I was picking up bales. Half throttle type work. After 2 hrs the coil goes dead again. I grabbed it and it was warm but no where near hot. You could hold it in your hand.

What do I need to start looking at to cure this recurring problem ?


Thanks
Back to Top
Sponsored Links


Back to Top
DaveKamp View Drop Down
Orange Level Access
Orange Level Access
Avatar

Joined: 12 Apr 2010
Location: LeClaire, Ia
Points: 5754
Post Options Post Options   Thanks (0) Thanks(0)   Quote DaveKamp Quote  Post ReplyReply Direct Link To This Post Posted: 25 Aug 2024 at 12:05am
Start by doing this:

Get a jumper wire, connect it from battery to coil power connection (bypass the ignition switch) and start it up.

Run it, and see if it eventually stalls.

If it doesn't, your failed coil is actually a failing RUN contact on the ignition switch.

They do fail... don't ask how I know...
Ten Amendments, Ten Commandments, and one Golden Rule solve most every problem. Citrus hand-cleaner with Pumice does the rest.
Back to Top
AaronSEIA View Drop Down
Orange Level
Orange Level


Joined: 11 Sep 2009
Location: Mt Pleasant, IA
Points: 2551
Post Options Post Options   Thanks (0) Thanks(0)   Quote AaronSEIA Quote  Post ReplyReply Direct Link To This Post Posted: 25 Aug 2024 at 6:25am
Get a test light and see if it has voltage at both small terminals.  If it does now, run it till it dies and check again.
AaronSEIA
Back to Top
steve(ill) View Drop Down
Orange Level Access
Orange Level Access
Avatar

Joined: 11 Sep 2009
Location: illinois
Points: 81309
Post Options Post Options   Thanks (0) Thanks(0)   Quote steve(ill) Quote  Post ReplyReply Direct Link To This Post Posted: 25 Aug 2024 at 7:28am
6V coils or 12v coils ??? What is battery voltage ?
Like them all, but love the "B"s.
Back to Top
Nathan (SD) View Drop Down
Orange Level
Orange Level


Joined: 11 Sep 2009
Location: Day County SD
Points: 1262
Post Options Post Options   Thanks (0) Thanks(0)   Quote Nathan (SD) Quote  Post ReplyReply Direct Link To This Post Posted: 25 Aug 2024 at 8:20am
Originally posted by AaronSEIA AaronSEIA wrote:

Get a test light and see if it has voltage at both small terminals.  If it does now, run it till it dies and check again.
AaronSEIA

Yes. Full light on pos. Flicker light on neg as you spin engine over and points open and close. 
Back to Top
Nathan (SD) View Drop Down
Orange Level
Orange Level


Joined: 11 Sep 2009
Location: Day County SD
Points: 1262
Post Options Post Options   Thanks (0) Thanks(0)   Quote Nathan (SD) Quote  Post ReplyReply Direct Link To This Post Posted: 25 Aug 2024 at 8:21am
Originally posted by steve(ill) steve(ill) wrote:

6V coils or 12v coils ??? What is battery voltage ?

12 volt coils. 12 volt battery. 
Back to Top
steve(ill) View Drop Down
Orange Level Access
Orange Level Access
Avatar

Joined: 11 Sep 2009
Location: illinois
Points: 81309
Post Options Post Options   Thanks (0) Thanks(0)   Quote steve(ill) Quote  Post ReplyReply Direct Link To This Post Posted: 25 Aug 2024 at 9:42am
i was just thinking out loud if the "NEW" coil could have been a 6V or needed an external resistor and you put it on the 12v.... and had too much voltage..

Could also just be a concidence that you have two "OLD" coils ?
Like them all, but love the "B"s.
Back to Top
Nathan (SD) View Drop Down
Orange Level
Orange Level


Joined: 11 Sep 2009
Location: Day County SD
Points: 1262
Post Options Post Options   Thanks (0) Thanks(0)   Quote Nathan (SD) Quote  Post ReplyReply Direct Link To This Post Posted: 25 Aug 2024 at 3:13pm
Today it popped right off and ran a hour or so and the coil fizzled again. Put another coil on and kept going. Thinking it is probably all related to aged coils so far.
Back to Top
Steve in NJ View Drop Down
Orange Level Access
Orange Level Access
Avatar

Joined: 12 Sep 2009
Location: Andover, NJ
Points: 11823
Post Options Post Options   Thanks (0) Thanks(0)   Quote Steve in NJ Quote  Post ReplyReply Direct Link To This Post Posted: 26 Aug 2024 at 10:40am
I don't think it's aged coils. It could be aged wiring or possibly a bad Ignition switch as Dave mentioned. D17's also used those useless Ballast resistors as well. If your D17 has one of them things hanging on it, get rid of it and put a new 12V/3.0 Ohm internal resisted Coil on it. But, before you do that, better check the wiring on board that thing. Old wiring causes a lot of issues which make the Gremlins come out. It's one thing to burn up a couple old Coils, it sucks to burn up a new one!.....
Steve@B&B
39'RC, 43'WC, 48'B, 49'G, 50'WF, 65 Big 10, 67'B-110, 75'716H, 2-620's, & a Motorhead wife
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.063 seconds.


Help Support the
Unofficial Allis Forum