This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity. | ||||||
The Forum | Parts and Services | Unofficial Allis Store | Tractor Shows | Serial Numbers | History |
D17 ignition coil |
Post Reply |
Author | |
Nathan (SD)
Orange Level Joined: 11 Sep 2009 Location: Day County SD Points: 1262 |
Post Options
Thanks(0)
Posted: 24 Aug 2024 at 10:33pm |
D17 fried a coil a few days ago. Died in the yard and didn’t deal with it until the next day because I thought it ran out of gas. Turns out the coil was dead. Replaced it with one I had in stock from another tractor. Today I was picking up bales. Half throttle type work. After 2 hrs the coil goes dead again. I grabbed it and it was warm but no where near hot. You could hold it in your hand.
What do I need to start looking at to cure this recurring problem ? Thanks |
|
Sponsored Links | |
DaveKamp
Orange Level Access Joined: 12 Apr 2010 Location: LeClaire, Ia Points: 5754 |
Post Options
Thanks(0)
|
Start by doing this: Get a jumper wire, connect it from battery to coil power connection (bypass the ignition switch) and start it up. Run it, and see if it eventually stalls. If it doesn't, your failed coil is actually a failing RUN contact on the ignition switch. They do fail... don't ask how I know...
|
|
Ten Amendments, Ten Commandments, and one Golden Rule solve most every problem. Citrus hand-cleaner with Pumice does the rest.
|
|
AaronSEIA
Orange Level Joined: 11 Sep 2009 Location: Mt Pleasant, IA Points: 2551 |
Post Options
Thanks(0)
|
Get a test light and see if it has voltage at both small terminals. If it does now, run it till it dies and check again. AaronSEIA
|
|
steve(ill)
Orange Level Access Joined: 11 Sep 2009 Location: illinois Points: 81248 |
Post Options
Thanks(0)
|
6V coils or 12v coils ??? What is battery voltage ?
|
|
Like them all, but love the "B"s.
|
|
Nathan (SD)
Orange Level Joined: 11 Sep 2009 Location: Day County SD Points: 1262 |
Post Options
Thanks(0)
|
Yes. Full light on pos. Flicker light on neg as you spin engine over and points open and close.
|
|
Nathan (SD)
Orange Level Joined: 11 Sep 2009 Location: Day County SD Points: 1262 |
Post Options
Thanks(0)
|
12 volt coils. 12 volt battery.
|
|
steve(ill)
Orange Level Access Joined: 11 Sep 2009 Location: illinois Points: 81248 |
Post Options
Thanks(0)
|
i was just thinking out loud if the "NEW" coil could have been a 6V or needed an external resistor and you put it on the 12v.... and had too much voltage..
Could also just be a concidence that you have two "OLD" coils ?
|
|
Like them all, but love the "B"s.
|
|
Nathan (SD)
Orange Level Joined: 11 Sep 2009 Location: Day County SD Points: 1262 |
Post Options
Thanks(0)
|
Today it popped right off and ran a hour or so and the coil fizzled again. Put another coil on and kept going. Thinking it is probably all related to aged coils so far.
|
|
Steve in NJ
Orange Level Access Joined: 12 Sep 2009 Location: Andover, NJ Points: 11816 |
Post Options
Thanks(0)
|
I don't think it's aged coils. It could be aged wiring or possibly a bad Ignition switch as Dave mentioned. D17's also used those useless Ballast resistors as well. If your D17 has one of them things hanging on it, get rid of it and put a new 12V/3.0 Ohm internal resisted Coil on it. But, before you do that, better check the wiring on board that thing. Old wiring causes a lot of issues which make the Gremlins come out. It's one thing to burn up a couple old Coils, it sucks to burn up a new one!..... Steve@B&B
|
|
39'RC, 43'WC, 48'B, 49'G, 50'WF, 65 Big 10, 67'B-110, 75'716H, 2-620's, & a Motorhead wife
|
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |