![]() |
This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity. | |||||
The Forum | Parts and Services | Unofficial Allis Store | Tractor Shows | Serial Numbers | History |
ac d17 gas hydralic problem |
Post Reply ![]() |
Author | |
mayagent ![]() Bronze Level ![]() ![]() Joined: 20 Jun 2015 Location: terre haute, in Points: 3 |
![]() ![]() ![]() ![]() ![]() Posted: 20 Jun 2015 at 12:31pm |
went to pick up pallet of broken concrete about 300 lbs and after it got up in air it fell down and wouldn't raise, no pressure on lever now, checked rods under side panel and there till connected rod runs down center of frame with plates under frame. Any suggestions, i'm clueless about the d17. thanks please reply to my email at mayagent@frontier.com Any advice or help greatly appreciated!!!!!!!!!!
|
|
![]() |
|
Sponsored Links | |
![]() |
|
CTuckerNWIL ![]() Orange Level ![]() ![]() Joined: 11 Sep 2009 Location: NW Illinois Points: 22825 |
![]() ![]() ![]() ![]() ![]() |
Sounds like what my WD45 did when the shoulder broke off the relief spool. Had to remove the pump and rebuild it with a new spool.
|
|
http://www.ae-ta.com
Lena 1935 WC12xxx, Willie 1951 CA6xx Dad bought new, 1954WD45 PS, 1960 D17 NF |
|
![]() |
|
mayagent ![]() Bronze Level ![]() ![]() Joined: 20 Jun 2015 Location: terre haute, in Points: 3 |
![]() ![]() ![]() ![]() ![]() |
So how big of a job is that where is the pump and how do you remove it Thanks
|
|
![]() |
|
Don(MO) ![]() Orange Level ![]() Joined: 12 Sep 2009 Location: Bates City MO. Points: 6862 |
![]() ![]() ![]() ![]() ![]() |
I'd check the oil level in the HYD and trans/rear end first, if you have lost hdy oil and now the trans/ rear end oil level is now over full then I'd look at the lift cyl or hose.
|
|
3 WD45's with power steering,G,D15 fork lift,D19, W-Speed Patrol, "A" Gleaner with a 330 corn head,"66" combine,roto-baler, and lots of Snap Coupler implements to make them work for their keep.
|
|
![]() |
|
DSeries4 ![]() Orange Level ![]() ![]() Joined: 12 Sep 2009 Location: Ontario, Canada Points: 7505 |
![]() ![]() ![]() ![]() ![]() |
I would agree with Don. Start with the hydraulic hose that feeds the cylinder. You need to pull the rear housing off the tractor to do that.
|
|
'49 G, '54 WD45, '55 CA, '56 WD45D, '57 WD45, '58 D14, '59 D14, '60 D14, '63 D15D, '66 D15II, '66 D21II, '67 D17IV, '67 D17IVD, '67 190XTD, '73 620, '76 185, '77 175, '84 8030, '85 6080
|
|
![]() |
Post Reply ![]() |
|
Tweet
|
Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |