| Author |
 Topic Search  Topic Options
|
lukeWI 
Orange Level
Joined: 13 Sep 2009
Location: elmwood,wi
Points: 802
|
 Post Options
 Thanks(0)
 Quote  Reply
 Topic: wanted IB parts
Posted: 02 Mar 2010 at 7:02pm |
|
i am looking for anyone who has some Ib parts or has parted out an IB. i am needing a steering column, left fender, draw bar set up, choke and starter rod. thanks for any help, either send me a message or call me at 715-317-0017. thanks
|
 |
|
Sponsored Links
|
|
|
steve(ill)
Orange Level Access
Joined: 11 Sep 2009
Location: illinois
Points: 82317
|
Post Options
Thanks(0)
Quote Reply
Posted: 02 Mar 2010 at 9:02pm |
|
luke, if you dont get any takers--- you can cut down a B steering column to make that, you can modify a WD fender to use on the IB, and the choke and starter rod can be made from round bar stock.
|
|
Like them all, but love the "B"s.
|
|
GlenninPA
Orange Level
Joined: 11 Sep 2009
Location: Ashley, PA
Points: 5054
|
Post Options
Thanks(0)
Quote Reply
Posted: 02 Mar 2010 at 9:11pm |
luke,
Are you looking for the steering column tube, or the shaft with the worm on the end?
If you are looking for the shaft with the worm gear, I could measure the NOS one I have here for you. You would need to take a regular B shaft and cut a piece out of the middle and reweld it. It is hollow, so you should be able to put a rod inside to reinforce the joint area. If it is just the tube, they are easily made from some thinwall tubing.
Glenn
|
|
Herb(GA)
Orange Level Access
Joined: 15 Sep 2009
Location: United States
Points: 1039
|
Post Options
Thanks(0)
Quote Reply
Posted: 02 Mar 2010 at 9:23pm |
|
Roger VanCamp has some IB's being parted; ph 260-747-3455. Fort Wayne, IN, near the airport. Leave it ring a while as Rogers hearing isn't that great, and his pace is getting a little slower; sorta like someone else I know. Herb
|
|
Cal
Silver Level
Joined: 14 Sep 2009
Location: East Woodstock
Points: 172
|
Post Options
Thanks(0)
Quote Reply
Posted: 02 Mar 2010 at 9:48pm |
|
Luke I used 2 new fenders from stiener on my IB and they came out good. You need to flatten the forward lower boss to use the WD fender and then copy the flat block off plate from the old IB fender. Cal in Ct.
|
|
Steve in NJ
Orange Level Access
Joined: 12 Sep 2009
Location: Andover, NJ
Points: 11885
|
Post Options
Thanks(0)
Quote Reply
Posted: 03 Mar 2010 at 11:40am |
When I restored my IB, I purchased a couple WD fenders from Tony C. A little bit of alteration that my body man did, using the IB fenders as patterns, and I had a sweet lookin' set of IB fenders! I also made my starter rod and made the rest of the foot throttle linkage that was missing. That was a fun project though I must say...
|
|
