This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


C main transmission shaft removal
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
wisjoe View Drop Down
Silver Level
Silver Level
Avatar

Joined: 02 Jan 2012
Location: Montello, WI
Points: 53 		Post Options Post Options   Thanks (0) Thanks(0)   Quote wisjoe Quote  Post ReplyReply Direct Link To This Post Topic: C main transmission shaft removal
    Posted: 31 May 2019 at 1:28pm
I have my C split in 3 to replace the clutch shaft and main transmission shaft. I have the pto housing off and the transmission shaft as far forward as it will go. How do I get at the snap ring so I can get the shaft all of the way out. The service manual doesn't fully explain it or I'm just not getting it. Do I have to take off the final drive housing to get at it? I think I may be in over my head. Thanks, Joe.Confused
Just living the dream, with an occasional nightmare!!!
Back to Top
Sponsored Links


Back to Top
Dick L View Drop Down
Orange Level
Orange Level
Avatar

Joined: 12 Sep 2009
Location: Edon Ohio
Points: 5093 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Dick L Quote  Post ReplyReply Direct Link To This Post Posted: 31 May 2019 at 3:09pm
I have always removed the finals and stripped the case bare to clean so I could inspect every part and reassembled. It has been a few years but I don't remember any disassembling problems. There is a cup in the upper back that oils the short shaft that fills with crud that would be hard to clean with the gears in.

Back to Top
wisjoe View Drop Down
Silver Level
Silver Level
Avatar

Joined: 02 Jan 2012
Location: Montello, WI
Points: 53 		Post Options Post Options   Thanks (0) Thanks(0)   Quote wisjoe Quote  Post ReplyReply Direct Link To This Post Posted: 01 Jun 2019 at 10:22pm
  With the help of a friend the transmission is apart. Waiting for a few parts and reassembly will begin. Thank you, Joe
Just living the dream, with an occasional nightmare!!!
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.102 seconds.


Help Support the
Unofficial Allis Forum