This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


Allis Chalmers Plow Parts
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
WNYBill View Drop Down
Silver Level
Silver Level


Joined: 04 Jun 2016
Location: WNY
Points: 276 		Post Options Post Options   Thanks (0) Thanks(0)   Quote WNYBill Quote  Post ReplyReply Direct Link To This Post Topic: Allis Chalmers Plow Parts
    Posted: 30 May 2017 at 4:02pm
So I broke the LIFT SHAFT on my AC Series 82 Plow.   Built a new one out of 2 inch hot roll.   Not hard enough, I keep bending it where it goes through the plow frame.  

Where do I start looking for a replacement?   Or do I just bite the bullet and go shopping for a new plow?

Bill
Back to Top
Sponsored Links


Back to Top
Matt (Jordan,MN) View Drop Down
Orange Level
Orange Level


Joined: 12 Sep 2009
Location: Jordan, MN
Points: 3790 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Matt (Jordan,MN) Quote  Post ReplyReply Direct Link To This Post Posted: 30 May 2017 at 5:48pm
contact this guy
Dave the Plowman
Owner of Matt Scott LLC
Specializing in NOS and used Allis Chalmers tractor & implement parts & liturature and Magneto Repair
http://www.mattscottllc.com/
Back to Top
jbirnsch View Drop Down
Bronze Level
Bronze Level


Joined: 02 Jun 2010
Location: Egg Harbor, WI
Points: 78 		Post Options Post Options   Thanks (0) Thanks(0)   Quote jbirnsch Quote  Post ReplyReply Direct Link To This Post Posted: 30 May 2017 at 6:35pm
What about using corten ASTM 588 rod? We have a stone fork built with these rods and they do not bend very easy. 
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.078 seconds.


Help Support the
Unofficial Allis Forum