This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity. | ||||||
The Forum | Parts and Services | Unofficial Allis Store | Tractor Shows | Serial Numbers | History |
What size wrench takes bull gear nut off C? |
Post Reply |
Author | |
Wes (VA)
Orange Level Joined: 12 Sep 2009 Location: Elkton, VA Points: 510 |
Post Options
Thanks(0)
Posted: 28 Sep 2009 at 8:09pm |
Just like the title says.. Is it the same size nut thats on the outer end of the axle shaft on the model B?? Thanks, Wes
|
|
Sponsored Links | |
steve(ill)
Orange Level Access Joined: 11 Sep 2009 Location: illinois Points: 81826 |
Post Options
Thanks(0)
|
I use the same wrench inside and out on the B. My wrench is cut out of a 3/8 inch thick plate. Width is kind of tight for a regular wrench.
|
|
Like them all, but love the "B"s.
|
|
Wes (VA)
Orange Level Joined: 12 Sep 2009 Location: Elkton, VA Points: 510 |
Post Options
Thanks(0)
|
Ok thanks Steve.. I came in and didn't even think about measuring the nut inside compared to the B's outer nut. Just kinda thought it would be about the same. And thats good to know about the width, I was gonna look for a wrench, but I think I'll have to make one up as well. Thanks again. -Wes
|
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |