HD5G throttle control lever quit
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Construction and other equipment
Forum Description: everything else with orange (or yellow) paint
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=83936
Printed Date: 26 Jun 2024 at 8:12am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: HD5G throttle control lever quit
Posted By: Osage_Orange
Subject: HD5G throttle control lever quit
Date Posted: 28 Jan 2014 at 9:00am
maintaining position. It goes back to idle position if not held externally. I finished my job earlier this week by placing a "stick" between lever and housing (very professional, eh?). I looked in the service manual to see what the inside looks like. Just trying to get a jump on things while too cold to work outside (+8*F this AM), what usually fails inside these things? I'm hoping its just a broken spring. ------------- Why is there never time to do it right the first time, but always time to go back and fix it? |
Replies:
Posted By: Coke-in-MN
Date Posted: 28 Jan 2014 at 10:15am
|
Two different designs were used on throttle control , both using a friction device to hold position . One is thin pancake appearance and later is thicker unit with a bolt showing on the one edge . ( tighten the bolt some ot increase friction. ) ------------- Faith isn't a jump in the dark. It is a walk in the light. Faith is not guessing; it is knowing something. "Challenges are what make life interesting; overcoming them is what makes life meaningful." |