working on new pulling parts(pics)
Printed From: Unofficial Allis
Category: Other Topics
Forum Name: Pulling Forum
Forum Description: Forum dedicated to Tractor and Garden Pulling
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=83788
Printed Date: 05 Jun 2024 at 8:14am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: working on new pulling parts(pics)
Posted By: patrickmull
Subject: working on new pulling parts(pics)
Date Posted: 25 Jan 2014 at 2:46pm
built a new new set of wheel centers and made 3 sets of weld on axle plates and machined 2 sets of axles for 2 IH 560s the centers are for my wc they weigh 20#   |
Replies:
Posted By: cwhit
Date Posted: 25 Jan 2014 at 6:41pm
|
I think I know of a wide front 45 with rear wheels like those. :)
Yours look nice Patrick.
|
Posted By: XT in pa
Date Posted: 25 Jan 2014 at 7:43pm
|
Ok I was goin to make some like that for a 17 puller ? Do you think they will handle some serious hp or would you be limited. Btw that's some great work you do. Shawn. ------------- 190XT,D17and 7045 |
Posted By: patrickmull
Date Posted: 25 Jan 2014 at 11:22pm
| they will hold up i have seen them on a hot 17 they seem pretty stout there is an outfit (cap bros ) that makes them that pull up to the 13000# class these will go to the 6500 just didnt want to pay $500 plus $25 shipping when i can make them my self |
Posted By: Jasonillinois
Date Posted: 26 Jan 2014 at 7:47am
|
Nice looking work. What thickness of tubing are you using? I've been kicking around making a set for my WC as well. Thanks Jason |
Posted By: patrickmull
Date Posted: 26 Jan 2014 at 10:03am
| 2x4x 1/8" the center is 1/4" plate wrapped with 1/4"x 2" flat |
Posted By: JayIN
Date Posted: 27 Jan 2014 at 10:56am
|
What size is that wheel? ------------- sometimes I walk out to my shop and look around and think "Who's the idiot that owns this place?" |
Posted By: patrickmull
Date Posted: 27 Jan 2014 at 3:55pm
| 38" x 15" wide i run 15.5 x 38 tires on my wc i picked up a nice set of Firestone 151s old and hard with 11/4" tread i am going to have them cut |
Posted By: bmartin55
Date Posted: 27 Jan 2014 at 10:16pm
| can u send measurements of bolt patern to make a set of plates.. THANKS bob.. |
Posted By: patrickmull
Date Posted: 28 Jan 2014 at 3:36am
| i will get the numbers i drilled it on a digital read out mill i cut it out with a planeograph troch |