Farm Equipment - 9 bolt hubs -Int. to AC D21

Print Page | Close Window

9 bolt hubs -Int. to AC D21

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=7060
Printed Date: 16 Jan 2025 at 11:48pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: 9 bolt hubs -Int. to AC D21

Posted By: DougG
Subject: 9 bolt hubs -Int. to AC D21
Date Posted: 23 Jan 2010 at 5:04pm

Will a 9 bolt hub for pressed steel wheels of a 1066 Int. with 3.25 axles work on a D21? The axles are the same but is it keyed the same ?

Replies:

Posted By: Eric NY
Date Posted: 23 Jan 2010 at 5:28pm

Doug, The keyway in the axle is entirely different on a 1066.....almost a double type keyway. Eric NY

Posted By: JK(IN)
Date Posted: 23 Jan 2010 at 5:40pm

IH won't work, but older 9 bolt JD and Case share the same keyway. I looked all over for my two-ten and found a set off of a 4320 JD I believe. They worked great. Good luck.

Posted By: jeffnil
Date Posted: 23 Jan 2010 at 6:43pm

I have a set of nine bolt hubs off of a 210 if interested

Posted By: Dale Hardtke
Date Posted: 23 Jan 2010 at 7:27pm

A custom made key is the answer to fitting a 3.250 Dia. hub of a different Mfg. to a D-21 axle. I've done this with Massy 32" wheel center castings on a D-21. I would be able to make most any cross section key required. (262) 719 3552 Dale

Posted By: Calvin Schmidt
Date Posted: 23 Jan 2010 at 7:41pm

I used Massey 44 9 bolt hubs on a D-19. The keyways were different but that was solved with a special machined key.

Posted By: Jordan(OH)
Date Posted: 23 Jan 2010 at 10:08pm

210 hubs won't work, the have a 3-5/8 axle.