Construction and other equipment - Parts needed for HD3

Print Page | Close Window

Parts needed for HD3

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Construction and other equipment
Forum Description: everything else with orange (or yellow) paint
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=4894
Printed Date: 21 Feb 2025 at 6:26am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: Parts needed for HD3

Posted By: ChuckLuedtkeSEWI
Subject: Parts needed for HD3
Date Posted: 09 Dec 2009 at 10:07am

Looking for a couple of parts for my HD3.

set of hood panels for early HD3 with oil bath air cleaner.

Does anyone make replacement seat cushions? All of mine are shot.

Tach cable as mine is broken and most of the flexible shaft is missing.

Where can I get rebuild kits for the hydraulic rams on the loader? One of my rams is leaking pretty good.

Also, this is the needle in the haystack. Three point arms are missing off of the back. Is this three point similar to any of AC's tractors as finding a junk H3 or HD3 with a good three point is probably slim to none.

I will have to get a wiring harness for it yet, but that's last on my list and

Thanks for any help.

Replies:

Posted By: Bud(WI)
Date Posted: 09 Dec 2009 at 11:52am

Chuck - Don't know which tach parts are available from AGCO yet, but the parts books show the same numbers as a D15 diesel tractor. The numbers for the 3 point are different...

Posted By: Kipn
Date Posted: 09 Dec 2009 at 2:17pm

Any half decent upholstery can make them. I just bought some vinyl material, had some cording, measured the old plywood, traced out a pattern and sewed it together, some foam and stapled to new plywood. I sent a cylinder out to an hydraulic shop and had it fixed for $100.