Farm Equipment - 175 clutch question part 2

Print Page | Close Window

175 clutch question part 2

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=47912
Printed Date: 26 Aug 2025 at 8:12am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: 175 clutch question part 2

Posted By: Joe/NC
Subject: 175 clutch question part 2
Date Posted: 25 Mar 2012 at 8:08pm

we have determined the shifter shaft retainer came off the clutch shifter fork shaft. The shaft must have come out the hole in the torque tube. Has anyone had this experience and is there any way to fix this w/o pulling the tractor into? It appears there is a hole at the bottom of the torque tube that on end got in, is the housing machined at the top for the shaft to fit? Hope this makes sense

Thanks,

Joe/NC

Replies:

Posted By: Tracy Martin TN
Date Posted: 25 Mar 2012 at 8:13pm

It can be done with patience. You will need a pin made that will have retainer provisions outside the torque tube. It would be possible to use a original, but putting the little clip above fork pivot is almost impossible, almost but can be done. Good Luck! Tracy Martin

-------------
No greater gift than healthy grandkids!