Farm Equipment - D15 Series I, D15 Series II

Print Page | Close Window

D15 Series I, D15 Series II

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=47639
Printed Date: 28 Aug 2025 at 10:43pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: D15 Series I, D15 Series II

Posted By: Macon Rounds
Subject: D15 Series I, D15 Series II
Date Posted: 20 Mar 2012 at 2:44pm

Heres a question for you D15 experts. Can a D15 series I transmission and transmission housing be used on a D15 series II tractor? I plan on using the Series II final drives and the factory 3 point hitch.

Thanks in advance

Ben AKA Macon Rounds

-------------
The Allis "D" Series Tractors, Gravely Walk behind Tractors, Cowboy Action Shooting !!!!!!! And Checkmate

Replies:

Posted By: RichinWis
Date Posted: 20 Mar 2012 at 4:29pm

I would certainly believe so, the same 3 point hitch setup was for both series I & II. That same option was avalible for both series. HTH

Posted By: Macon Rounds
Date Posted: 20 Mar 2012 at 6:21pm

I know the series II had a different brake system. Does it swap over with the axle housings?

-------------
The Allis "D" Series Tractors, Gravely Walk behind Tractors, Cowboy Action Shooting !!!!!!! And Checkmate

Posted By: PaulB
Date Posted: 20 Mar 2012 at 6:37pm

the differenc in the brakes was the lining on the shoes. As said, the factory 3pt will bolt on the series I tractor, Just be sure to conastantly check the mounting bolts to be sure that they're tight. Until the D17 became the series IV, an Allis 3pt had a lot to be desired. The early designs did not have enough bolt in different directions to handle the stress loads that are incountered with a 3pt. The AC adapter from the snap couple is much better: the loade is carried by the lift arms and it will pivot up under the tractor at the SC bell.

Posted By: Calvin Schmidt
Date Posted: 20 Mar 2012 at 7:40pm

I have a D-14 transmission in a D-15D series I. Only part number different was 2nd gear and the D-14 number was updated to the D-15 number in the parts book . You can change from snap coupler to 3 pt without changing the housing.

-------------
Nothing is impossible if it is properly financed

Posted By: Macon Rounds
Date Posted: 20 Mar 2012 at 8:55pm

Found this neglected series I nerrow front with a good tranny. My series II has a bad transmission and good engine. I have read and spoke with folks about repairing the transmission but even my ring gear has a tooth that is chiped. Been looking for a donor tractor for a long time and i believe i have found one. Sounding good as a swap project.

Thanks for your input and suggestions

Ben AKA Macon ROunds

-------------
The Allis "D" Series Tractors, Gravely Walk behind Tractors, Cowboy Action Shooting !!!!!!! And Checkmate

Posted By: Macon Rounds
Date Posted: 21 Mar 2012 at 9:17pm

deal

-------------
The Allis "D" Series Tractors, Gravely Walk behind Tractors, Cowboy Action Shooting !!!!!!! And Checkmate

Posted By: Macon Rounds
Date Posted: 21 Mar 2012 at 9:21pm

deal fell through, back to square one. :-(

-------------
The Allis "D" Series Tractors, Gravely Walk behind Tractors, Cowboy Action Shooting !!!!!!! And Checkmate