HD11 Sprocket Removal
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Construction and other equipment
Forum Description: everything else with orange (or yellow) paint
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=44721
Printed Date: 16 Jun 2024 at 4:15am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: HD11 Sprocket Removal
Posted By: Argo2
Subject: HD11 Sprocket Removal
Date Posted: 30 Jan 2012 at 3:11pm
After I get the track off how do I get the rear drive sprocket off? Do I need a hydraulic puller?
I have to replace the main oil seal behind the drive sprocket. Any one ever done this in this and what kind of job is it?
|
Replies:
Posted By: Mactractor
Date Posted: 30 Jan 2012 at 4:05pm
|
If you are lucky, driving wedges in between sprocket and drive housing loading the sprocket with tention, then using a copper or aluminium buffer on the end of the shaft to protect it, hitting on the end of the shaft, or lowering the bottom of the sprocket onto hard surface, and hitting down onto top of sprocket may be enough to spring it off the spline. Unfortunately, HD6 is usually the biggest tractor these methods work on. With HD11 and bigger, Hydraulic pull/push gear is usually used to do sprockets. Track shops have that gear
|
Posted By: Steve allis dozer
Date Posted: 30 Jan 2012 at 5:08pm
|
if you use a puller make sure to leave the nut on the shaft to catch the sprocket , undo the nut a couple of turns ,
|
Posted By: CAL(KS)
Date Posted: 30 Jan 2012 at 7:14pm
|
give the sproket a few whacks with a sledge hammer, just took the sproket off 2 HD16's and luckily in both cases it popped off. and your seal is a positive type not a lip type, probably not leaking at the sealing rings but behind them.
good luck
-------------
Me -C,U,UC,WC,WD45,190XT,TL-12,145T,HD6G,HD16,HD20
Dad- WD, D17D, D19D, RT100A, 7020, 7080,7580, 2-8550's, 2-S77, HD15
|
Posted By: Argo2
Date Posted: 30 Jan 2012 at 7:55pm
What do you mean leaking behind. I was surprised to see what the new seal actually looked like. Spring loaded contraption.
Anyone know what this machine weighs with dozer and winch?
|
Posted By: CAL(KS)
Date Posted: 30 Jan 2012 at 8:03pm
|
one side is not spring loaded its cemented to a gasket. sometimes the spring loaded side can leak through also. where on earth did you find a new one?
HD11 is around 23,000# and up, depending on series and configuration
-------------
Me -C,U,UC,WC,WD45,190XT,TL-12,145T,HD6G,HD16,HD20
Dad- WD, D17D, D19D, RT100A, 7020, 7080,7580, 2-8550's, 2-S77, HD15
|
Posted By: Mactractor
Date Posted: 31 Jan 2012 at 3:26am
|
HD11EP with blade, winch, and ROPS roll cage goes over 33000. Series B 11 with that gear will be over 35000
|
|