7020 pto
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=36859
Printed Date: 11 Aug 2025 at 8:26pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: 7020 pto
Posted By: jjpetrich
Subject: 7020 pto
Date Posted: 06 Sep 2011 at 11:06pm
|
Back pto has a little play in it. just wondering if its a bearing that was going out or could be a bigger problem.
|
Replies:
Posted By: Orange Blood
Date Posted: 07 Sep 2011 at 5:03am
Just a couple stupid questions, are all the bolts around the outside edge tight? Where the flanges clean before bolting it up? Define a little? all shafts and bearings have a very small amount of play in them. are we talking thousands, or tenths of inches of play, and which dirrection are you talking? Up and down, or in and out?
-------------
Still in use:
HD7 WC C CA WD 2-WD45 WD45LP WD45D D14 3-D17 D17LP 2-D19D D19LP 190XTD 190XTLP 720 D21 220 7020 7030 7040 7045 3-7060
Projects: 3-U UC 2-G 2-B 2-C CA 7-WC RC WDLP WF D14 D21 210 7045 N7
|
Posted By: jjpetrich
Date Posted: 07 Sep 2011 at 8:27am
|
bolts are all tight and everything is clean it moves about a 1/4 of an inch side to side
|
Posted By: Orange Blood
Date Posted: 07 Sep 2011 at 9:28pm
sure sounds like a bearing is out, or a really badly worn shaft. It must be leaking oil too?? A 1/4" is way too much
-------------
Still in use:
HD7 WC C CA WD 2-WD45 WD45LP WD45D D14 3-D17 D17LP 2-D19D D19LP 190XTD 190XTLP 720 D21 220 7020 7030 7040 7045 3-7060
Projects: 3-U UC 2-G 2-B 2-C CA 7-WC RC WDLP WF D14 D21 210 7045 N7
|
|