Farm Equipment - WD Handclutch

Print Page | Close Window

WD Handclutch

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=32219
Printed Date: 21 Aug 2025 at 1:35pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: WD Handclutch

Posted By: Mike56073
Subject: WD Handclutch
Date Posted: 14 Jun 2011 at 11:03am

I've got a WD that I split awhile back to replace the bronze handclutch yoke, now when I release the handclutch lever, the lever falls all the way forward and something grinds inside. I've had a few of these tractors apart, but obviously I overlooked something on this one. Any ideas?

Replies:

Posted By: MACK
Date Posted: 14 Jun 2011 at 10:07pm

If I remember right the pins that sets in the forks are not centered, so if pins are to the front the lever will lay farther forward. MACK

Posted By: Mike56073
Date Posted: 15 Jun 2011 at 8:24am

Anybody ever had any luck replacing the yoke without splitting the tractor?

Posted By: dudley wallace
Date Posted: 15 Jun 2011 at 9:42am

mike check the snap ring on the input shaft if it is not on there it will let the hand clutch pack to travel to far forward and will try to engage the clutch or make a grinding noise maybe this will help dudley.

-------------
a member of hendricks county antique tractor and machinery association club.

Posted By: skipwelte
Date Posted: 15 Jun 2011 at 9:55am

You can replace the yoke without splitting the tractor, what dudley says makes sense too, check the end play on the clutch assy by moveing the lever with the cover off. HTH