Farm Equipment - 8030 & new holland balers

Print Page | Close Window

8030 & new holland balers

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=31563
Printed Date: 10 Mar 2025 at 8:09am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: 8030 & new holland balers

Posted By: bill2260
Subject: 8030 & new holland balers
Date Posted: 31 May 2011 at 3:12pm

Hello, I have an 8030 and need to switch my distance control for kick baler and idiot light for round baler to my 8030. Presently hooked at starter cable at starter on my 185. Where is the best place to hook the hot wires on the 8030 and where is the best place to run the cables thru the cab. Thanks in advance, Bill

Replies:

Posted By: Gregor
Date Posted: 31 May 2011 at 4:39pm

I hook electrical items under the dash (bottom plate) to the circuit breaker studs. I run GPS and raven 440 controller with 3 shutoffs for sprayer and never had any problems. I didn't want to make a hole in the cab up front. To get the cables out of the cab, there is a plate on the right side of the lower back window. I took the plates out to save for reuse and got 2 alumium flat plates and stuck in there. I put a piece of foam between them and drilled a hole. The foam works great to keep the cables from chaffing in the hole.